Steve ,
And yet again forum members come to the rescue. No doubt I would have installed the reman dist. I owe you, and many others, a beer. Steve, thank you so much for your assistance. I have contacted AFI to see if I can purchase either the guts or the entire unit directly from them.
Thank you. My AFI Fuel Injection is working fine. If you mean, am I going to repair the Distributor, I had planned on just swapping it out with a replacement. If I could purchase just the electronics part of the distributor that would be great, but don't think they are available.
The PO of my 72 FJ40 installed the AFI EFI system and electronic ignition by way of a distributor from a 3FE engine. Truck has been running great all summer, but now I am not getting any spark, and I think it may be the distributor. Is it possible to find a source for just the "electronic"...
Thank you, helped me also. Does this switch/lever arm have a self cancelling mechanism ? While both left and right signals work fine, the lever pops back to center from a right hand turn only, left hand, it stays on. Any advice would be appreciated.
thank hyou
Can someone help me with the fastener size for the turn signal unit, upper collar. The one that clamps it to the steering column. I believe its 8mm but not sure of the thread pitch.
1972 fj40
thank you
My 72 is fitted with a 77 stock exhaust. The PO used solid exhaust hangers, no rubber, bolted right the chassis. There are no hanger foundations. Initially I was going to try to make it original, however with the straight cushions NLA, I may just go with an aftermarket hanger.
any...
this is the output shaft for the driver side wiper arm on a 72. I broke the threaded portion off, damn. This is the only part I need, but if you need to sell the entire passenger side, I understand. My motor and all else is working fine.
thank you
Rebuild complete, (I thought), new tires and wheels and took it for my first ride. She was running hot, needle was steady and what would be the 75% area. Pulled over and found that it was pissing fluid from two spots on the inside of the radiator. Right at the seam between the coil area and...
does anyone have a photo, or can lead me to a photo, of the original set up inside the toolbox for a 72 fj40. Looking for placement of jack and tool holders. thanks