Recent content by Keith87VT

  1. Keith87VT

    Electrical demons

    So I bought an FJ60 last summer to use for offroading. I put some new tires on it, and welded the rear end. Other than that I have not done any mods to the vehicle. It is generally in very rough shape, but seems to have a strong engine. The issue that I am having is that I have only taken it out...
  2. Keith87VT

    Waterproofing under the hood

    So, I live in VT and with that comes an assortment of different conditions. A few weeks back I was with my buddies and attempted to go through some water and mud. I was able to clear the area, and the FJ started to sputter. I left her running in the sun with the hood open and she calmed down. On...
  3. Keith87VT

    Welding rear differential question

    He knows what he is doing, issue is he will only do the welding and I don't know what I am doing lol. Good thing you all exist and that I have an fsm
  4. Keith87VT

    Idle issues

    will do
  5. Keith87VT

    Idle issues

    we are gonna do circuit breaker I believe seems to be most expensive up front, but cheapest long term as its just hitting reset when it trips.
  6. Keith87VT

    Welding rear differential question

    So I have searched to no avail for the answer to this question. I am considering welding my rear dif. I know its a bad idea, but lets ignore that as I am not going to spend $300 on a locker for a truck I paid $800 for (but do plan on spending $1000 on tires). So I have a buddy who has a big...
  7. Keith87VT

    Idle issues

    So after work I went and played on the truck... Tested the fusible link 12 up to it, 6 out the back of it on wire w. Others were good. No voltage at any spot past the link in the wire diagram. Straight wired w to 12v and it went to all components at 12v including the ones I had tested before...
  8. Keith87VT

    Idle issues

    My guess from the diagrams is that all the issues are caused by this link. If alternator reg runs off port three as do other things or so it seems then port 3 may be the problem I just need confirmation I am reading right that port three labels with a w on the big full diagram runs the emissions...
  9. Keith87VT

    Idle issues

    I appreciate the help. Pictures make things way easier. I don't tend to ask a question until I have dug a little into the issue. Ie I had already done a search for fusable link both here and on google looking for an image of what I was looking for before asking, but it's my first trail rig so I...
  10. Keith87VT

    Idle issues

    I am not sure what we are talking about when we say fusable link.do you happen to have a picture of what we are talking about? And also how to test it.
  11. Keith87VT

    Idle issues

    measurements were taken with the key turned to "on" i believe... one click over where the dash light for choke and ebrake light up. we also tested with truck running and still had 0 volts.
  12. Keith87VT

    Idle issues

    So using a voltmeter I discovered a big issue... I have 0 volts reaching my emissions components. Tested at battery I have 12.7v, 6 inches away it's the same, but then the wires start to split and it's hard to follow where stuff goes so I tested the ics plug itself, the green plug on the...
  13. Keith87VT

    Idle issues

    So the one good thing in all this is that I have a parts rig with all these parts still in it. So later I am going to do the ground and swap alternators of it still has the issue I am going to pull ics from spare truck and see if that does anything. And if all still fails I'm gonna burn it...
  14. Keith87VT

    Idle issues

    No the battery wasn't charging alternator is def an issue, but the solenoid should have clicked even if the battery wasn't being refilled as long as it was fresh and reading 12v which it was at the time we tested the solenoid. Or is that assumption wrong? Does anyone have a picture of where to...
  15. Keith87VT

    Idle issues

    So I put a fresh battery in it... Read 12v on dash still had issue. Unplugged green and replugged no sound... So we are gonna do ics ground tomorrow and see if that does anything. if not I am going to start a desmog and pull the carb and have a buddy rebuild it.
Back
Top Bottom