Recent content by Karl Pollock

  1. Karl Pollock

    93 rough idle piss poor performance at lower RPM

    The warm up cycle makes sense. I drove the thing to work in a snow storm last week, that's 83 mi round trip mostly freeway but some city as well. I'll jumper the OBD over the holiday and see if anything pops up.
  2. Karl Pollock

    93 rough idle piss poor performance at lower RPM

    Got her all back together but I still have the same issues. It low idle and very low power until good and warm. Then everything is good. I put a jumper on the diagnose block to pull codes per the FSM and all the light did was blink steadily for around 30 seconds. Is that normal? Do I need to...
  3. Karl Pollock

    Did something dumb, now no oil pressure

    Dip sticks are over rated!
  4. Karl Pollock

    Did something dumb, now no oil pressure

    Ok. In full daylight, added 5.5 of oil +1.5 from last week = 7. So yes, almost all of the oil came out the hole. I removed the EFI relay and turned it over until high pressure on the gage, then let it sit a few then same again, started warmed up and reved to 3k, no expensive noises. Drove around...
  5. Karl Pollock

    Did something dumb, now no oil pressure

    I should clear the air. My LC is 1 of 5 vehicles I own and the only one that doesn't run well. I'm not too stressed out about the integrity of the engine, it's fine, that design is a brick s*** house it just needs more oil. I was more concerned about the horrible mess I made in the driveway...
  6. Karl Pollock

    Did something dumb, now no oil pressure

    The contaminated dirt will be disposed of in a legal fashion.
  7. Karl Pollock

    Did something dumb, now no oil pressure

    Before oil was added the very end of the dip stick was wet I did not check the level after adding.
  8. Karl Pollock

    Did something dumb, now no oil pressure

    In my own defense it was dark. As to volume of oil, it drained out onto the ground so it was pretty hard to judge. I've got half a wheelbarrow full of oily dirt to experiment with. I'll check the oil level tomorow when it's light out. If I get the same result I'll pull the coil wire and loosen...
  9. Karl Pollock

    Did something dumb, now no oil pressure

    I've been base lining my 93 1FZFE and finally got it back together accept for one part, the oil filter. I fired it up and let it fun for a minute then noticed no pressure! I killed it immediately, cleaned up the large mess in made added a quart and a half of oil and started it up again. The...
  10. Karl Pollock

    What Did You Do with Your 80 This Weekend?

    Continue baseline with harness insulation fix.
  11. Karl Pollock

    93 rough idle piss poor performance at lower RPM

    Ok, pictures of the harness insulation part II. And other assorted nincompoopery. The stock insulation fell off as soon as I touched it so I think I've got a good fix. Black tape first sticky side out then in. Makes a sleave then tiger patch muffler tape, over that I put aluminum tape to reflect...
  12. Karl Pollock

    Towing our 80 behind a Penske moving truck - they say it won't fit, will it?

    Is detaching the rear drive line and slapping it on a dolly an option?
  13. Karl Pollock

    Noob trying to get banana (maybe half banana)

    I am a huge fan of removing any assembly that gets in the way. In my experience it takes far less time and effort to remove say the battery or the air intake or whatever to gain access to the culprit assembly in any vehicle. You will get to know the machine better and resent repairing it less...
  14. Karl Pollock

    93 rough idle piss poor performance at lower RPM

    I had a look at the o2s while I was pulling the intake, they look pretty bad I don't think I can remove them without damage unless I pull the assembly there attached to. They're on the list of s*** to replace if what I'm doing now doesn't work. I've read here that Toyota recalled the 93s for o2...
  15. Karl Pollock

    93 rough idle piss poor performance at lower RPM

    finished t-body service this morning. All vac ports are clear and there are no aditional features, bench tested electronics all passed. Removed upper intake and fuel rail assembly. Injectors will go to Whitch Hunter for service this week. I'm having the upper cleaned by an engine shop near my...
Back
Top Bottom