Recent content by kaneenak

  1. kaneenak

    Wanted Rockingham, NC 3fe wanted

    Got a 91 fj80. Engine knocking Looking for another 3fe
  2. kaneenak

    No Spark

    We pulled the idle solenoid because we couldn't hear it "clicking". We directly connected it to the battery and the needle would extend and retract when voltage was applied and we could hear the click. However, we noted the needle on our seems to be slightly bent. I'm thinking that's not...
  3. kaneenak

    No Spark

    The fuel pump is working. Also, we can see gas squirting into the carb and the sight glass indicates gas in the carb. We need to check solenoid as I'm not sure about click. This morning we let the fuel pump run a little longer and pumped the accelerator quite a few times and it seemed to "want"...
  4. kaneenak

    No Spark

    Tonight we finally got her to crank but only by pouring gasoline into the carb and then she ran for a few seconds. We also noted the main belt is slipping a bit. We adjusted the fuel/air mixture screw per the repair manual we have - 1 and 1/4 turns out from fully closed. Still won't crank w/o...
  5. kaneenak

    No Spark

    Good News: we are getting voltage at coil (about 5 volts when on) and spark at plugs (not sure if it's "good enough" spark but it's progress). Problem was I had wire coming out of ballast resistor going to - of coil versus +. My lack of understanding. Bad News: Reason I wonder if spark is good...
  6. kaneenak

    No Spark

    We have three coil's, The original as well as one we purchased that says on the side that it needs an external resistor, as well as the another that we purchased (chrome one).that has no such indication on the side. The original measures no resistance post to post. both of the other two...
  7. kaneenak

    No Spark

    Thanks guys. I am so thankful to have a forum like this. We haven't solved the problem yet but we appreciate the input/ideas because we had kind of hit a dead end. Plus, at this point, we needed a good laugh which the over-engineering comment and clarification that we have an "FJ40" provided...
  8. kaneenak

    No Spark

    The FJ *was* running before we started working on it. ;-) Well, let me elaborate. We had to pour gas into the carb to get her to start and she would run nicely until the gas was used. We (my son) has since cleaned and rebuilt the carb, replaced the starter, and a few other components that...
  9. kaneenak

    No Spark

    We are having an issue getting spark on our 1972 FJ40. We have verified we are getting the correct voltage at the coil (between 7 and 8 volts) and more (around 12) when starting. However, nothing is coming out of the coil. We're replaced the coil, condenser, coil wire, wiring, and today...
  10. kaneenak

    Fixing up FJ40

    My son ended up cleaning and rebuilding his carb. He did a nice job. He also replaced the starter. However, at this point the FJ won't start. We have verified we are getting the correct voltage at the coil (between 7 and 8 volts) and more when starting. However, nothing is coming out of the...
  11. kaneenak

    Wanted 1972 FJ40 Carb Parts (USA-NC)

    We are trying to locate a couple replacement parts for our 1972 FJ40 as part of our carburetor rebuild. 1. We damaged the "discharge weight stopper" while removing it. 2. The "screen" was apparently missing. We have found the parts here but they are not available: Search by Part Number 042-27...
  12. kaneenak

    Fixing up FJ40

    Needed...Replacement Discharge Weight Stopper for 72 Carburetor We are trying to locate a couple replacement parts for our 1972 FJ40 as part of our carburetor rebuild. 1. We damaged the "discharge weight stopper" while removing it. 2. The "screen" was apparently missing. We have found the...
  13. kaneenak

    Fixing up FJ40

    Here's some additional photos of the FJ40 as it sat prior to our purchasing it. orig hood raised by kaneenak posted Nov 25, 2015 at 4:56 PM orig rear by kaneenak posted Nov 25, 2015 at 4:57 PM orig engine #1 by kaneenak posted Nov 25, 2015 at 4:54 PM Original Front by kaneenak posted Nov 25...
  14. kaneenak

    Fixing up FJ40

    My son and I are working on this 1972 FJ40 for him. We are both rather new to doing any serious type of automotive work but we are learning and having fun doing it. We are hoping we haven't bitten off more than we can chew. :-) Currently we are rebuilding the carburetor using some nice...
Back
Top Bottom