Reviving this thread to update. It ran fine after with no smoke but a whistle started developing around 1500 rpm’s and got more consistent and louder. I ran gumout bottles through about 4 tanks.
Then after my battery died this spring and it sat for a month or two, I replaced the battery and...
Heater fan was going crazy when I tried to burp coolant and smelled like death. Looks like 2 mice made a nice warm home in my blower until I had to go ruin it for them. Cross your fingers this is the last of my woes for a while…goodness.
Yeah, it’s just fine. I couldn’t get coolant leak fixed so that’s how I found I did the gasket wrong lol. I’ll be sure to clean her out for the next few tanks with gumout. Thanks.
I did. Unfortunately, the test drive revealed a leaking thermostat housing which made my drive belt slip off… never ending man. Luckily, no issues with the rest.
Also, that is the dot indicating left hand side next to LH letters you pointed to. The marks on it look like welded on speckles raised from the surface like the middle spot. I was showing it is raised up not pitted in.
I think both damaged valves are exhaust toward outside of block pointing to...
No sorry to cause confusion. Those marks you indicated near the center, the sharp lines, were from my scope. I was trying to see if it was water drop or soft and couldn’t get angled right, so I pressed against piston head to bend the scope a little more. Those were not there before that. The...
Oh no I didn’t think of that. Good idea. Why waste the coolant if there’s a problem evident in the first few seconds running. It won’t get warm enough to need it. I still need to plug in cylinder 1 and the air intake assembly. Got frustrated and it was late.
Yeah I heard about walnut dust sprayers. Seemed intriguing. Otherwise, I’d like to fix rather than replace eventually. Seems less wasteful. I was just riding high and now this is a bit of a bummer. Makes sense why my leak test on #1 was so horrible though.
Just need to add the plug and coil...