Recent content by joxeale

While I love my SC5s, I must say the clear on my wheels cracked like a week after mounting them. I wheel my rig so I know they'd say the clear got damaged due to that so i didn't bother going through customer service but just so everyone trying to get some knows that it could happen.

If you rip out the metal pipe and do a work around hose the PHH is a walk in the park. Hard part is removing the old hose.

Hot/Cold air blend door was stuck in the middle, always shooting out hot and cold air together. Eventually it started making noise trying to move to where it was supposed to be, I had to keep my temp sliding control in the middle, if I set it on fully cold it would start making noise. When I...

There are 3 mix motor thingys total. I had the same issue 'til I bit the bullet and removed my dash. Yes it sucked, not as bad as I thought but it was a pain. I had 2 of the 3 servos stuck. Junkyard servos installed, AC is Ice cold again.

From where? Pics? Link?

I had the code pop up on me while on the trail, it went away after clearing it a couple times. I will be getting the relay JIC. I dont drive my 80 often but when I do, I go far out and wheel it, need to have it 100%. Thanks for part # John

Good lord :wtf:

My exhaust is too far gone and i'm gonna go this route. Can you post a pic of where you welded the O2 bungs? No codes without cats? TIA

Thanks so much for the pics! Looks good

PM Sent.

Does anyone have this header with sliders? Preferably WK sliders? Trying to make sure they can work together before I order

Are you running sliders? If so, how was fitting the straight pipe in the bottom? Care to share a picture of how the exhaust sits with sliders installed?

How much for an antenna switch? 95-97

That 100k 80 has nothing on this. Incredible. Cheers

Only way out in my opinion :D