Recent content by Joshman

I never got back to note my fix on this one, but luckily this came down to mismatched battery post and aftermarket terminal clamp bore sizes. The military style clamps while correct on top of post was too open at bottom of post when tightened to regular “almost ready to strip tightness” (the...

Battery is 1 month old and tested fine last one lasted about 3+ years, but maybe that’s why AGM setting is reading a little below 100%.

Thanks, btw battery tests fine via Interstate test.

This one is a bugger, new battery month ago, and seems a bit different than the EFI fuse/fusebox "crank/ no start" issue - old battery was about 3 when it died - Big Interstate Group 31 AGM (little odd so short lived, but I live in the tropics and do low miles). Hopefully this is all some kind...

I talked to the guys over at Cruiser Outfitters and they said they know the problem and have not found any long term solution with a poly or rubber stop. So I think a little modification to the pocket is the way to go unless somebody’s willing to go thru a bunch of bump stops, to try and find a...

So l, I’ve got this same issue. Did you just take the edge of the pocket off or grind it all flat? Any chance you can snag a pic? I was thinking of maybe a rubber bump cap/ rubberize paint or replacement stop might work, grease is working for now but I’m guessing 1 month fix at most.

Problem: P0440 code about two weeks after re-installing gas tank - possible gas smell around vehicle, but not something strong enough to locate (doesn't seem to be in engine bay or at gas cap). Tank does not seem to be pressurizing (no hiss when removing gas cap - which I believe I normally had...

Yes - muffler looked great from the ground but the rear seam on muffler must have rotted from inside out, which sits right under the fill hose. My exhaust looked great from below -so I was figuring ethanol was the culprit to collapsed plastic in hose. The actual fill hose section burst because...

The exhaust leak is worrisome - I should have noticed when it sounded slightly louder or when my reverse cam quit (new). I just thought I had a bad connection or cam (though in my head that didn't make sense as I sealed all connections), let it go for a couple weeks then amp shutdown. Found the...

NO - The plastic inside is solid and can crack sending debris into fuel system - and if you are unlucky like me you have an exhaust issue causing it and it could POP on you (DID on me with hot exhaust at a gas station when I gave it a squeeze after second failure) look for melted plastic...

No cuts on Blueberry, it's the way it came - just paint - no body lift just hammering pinch welds and forming the liner + SPC UCAS, lift, spacers. I'll get to some more pictures soon- truck is finally in shop getting the 4.88's and lockers put in. Got some more paint and electrical to do and...

Well - this turned out me being too lazy to go into depth looking at the exhaust for leaks. The top off muffler had rot at the seam, thus firing some hot exhaust into the area.

285/75R18 Nitto Ridge Grapplers - Tundra Stocks w/ Slee Spacers - 2.5 Lift