Recent content by jonothehut

  1. J

    Minimum clearance space between wheel and tie rod/UCA??

    Super pro extended control arms. The blue ones. Can't remember exact tire size but I can check later. I know it is one size up from stock. If that helps.
  2. J

    Minimum clearance space between wheel and tie rod/UCA??

    Greetings, Was piddling around my rig the other day and noticed I have a very small amount of clearance between my tire and ball joint/tie rods/UCA. I cannot fit my finger through the gap. I have extended UCA and larger tires. What is the recommended gap size? Do I need to look into wheel...
  3. J

    AHC Delete = Vibration. Revert to stock LX470 spring?

    Makes sense. I did some searching and didn't find much information on carrier bearing shims for the 100 but seems rear upper and lower trailing arms would be able to adjust the rear pinion back to the correct angle.
  4. J

    AHC Delete = Vibration. Revert to stock LX470 spring?

    Gotcha. That makes sense. Thank you.
  5. J

    AHC Delete = Vibration. Revert to stock LX470 spring?

    My apologies if I wasn't clear earlier. No on maintaining the stock ride height currently. When I installed the Ironman kit I did gain about 2 inches of lift. About 2 in the front and 3 in the rear. Thats why I am curious to drop it back down to stock to see if that eliminates the vibration. Yes...
  6. J

    AHC Delete = Vibration. Revert to stock LX470 spring?

    As the title says, I have deleted my AHC. Replaced with Ironman suspension. Now I have a vibration under load around 60-75 mph. Vibration is not in the steering wheel. Felt on the pedal. The harder I press the pedal the harder the vibration is felt. Tires have been rotated and balanced a few...
  7. J

    What have you done to your 100 Series this week?

    Been looking for some decent looking but not overpriced seat covers. This may be exactly what I need. I am intrigued by the tan canvas. I have a LX as well. When ordering for the LC it came with armrest covers?
  8. J

    Exhaust Update

    I had a hole in my muffler and didn’t want to replace with stock or spend the money on Borla or something imported from Australia. I took my LX to an exhaust shop and had them put in a medium Magnaflow muffler, resonator delete and increase exhaust pipe from the Y flange to 3in. Not too loud...
  9. J

    New Member + LX470 middle seat cover question

    Good Morning, New member here. Been lurking for about a year but finally have a question I can't find an answer too when searching. But first the important thing, I've been driving a 2000 Lexus LX470, golden pearl for about 1 year. Exterior and interior needs some TLC but the engine is...
  10. J

    100 Series Mud Flap Eliminators

    Been lurking for a 6 months, finally remembered my password. Ordered! Shipping to SC!
Back
Top Bottom