Recent content by Joagmon

I have said snorkel and purchased off eBay. I think it $89 shipped to my door but that was 4 years ago.

Thanks, I’m pretty happy with them. Wasn’t exactly what I wanted but they turned out great. The color I wanted only came in high gloss, so they wouldn’t have looked right in my truck. These are a semi gloss finish. The black lugs nuts help darken them a little and I’m still debating on what to...

Tinted Steel from Prismatic Powders

Would’ve posted sooner but I just picked them and installed. These are 16’s but quite similar.

As stated above it could be road crown on your tires assuming they’re not new. It could also be tire pressure, brake lag, wheel bearings or torsion bars slightly uneven. After several alignments on mine and still pulling I dug in and discovered all of these things were affecting it. Is your...

As stated above, a bigger truck, a lighter boat, or closer to the water storage are your best options to consider.

I’ve had this tilt issue as well and found this solution to get it back down. Carefully pop the 4 pieces of black trim off of the glass frame. Remove the 4 bolts holding the glass to the track system. Remove the glass and push your tilt switch. The track should drop back into place and you can...

Trail Creeper.

You absolutely can, and with several different options. That’s the beauty of having the channels.

Don’t know why one couldn’t. Mine has the same crossbars as a prinsu, which I’ve seen a shadow awn on. I have a Batwing and ARB 2500 on mine with no issues in 3 years.

Heads up. My lateral bars are 15 series, .75”x1.5”x84” Just wanted to clear that up. All of my parts are 15 series.

The carriage bolts only secure the crossbars. Just slide in the track before attaching to the angle brackets on the side rails. I used stainless 5/16”x2.5” so I could utilize the same bolts for my awning brackets.

You are correct. To me it feels stronger and adds flexibility on placement of the crossbars and yes you can shim them if need be. Also a lot less angle brackets to mess with which also take up space.

I actually tried this out. It does work and clearance is great, but I didn’t like the aesthetics of it in the end. Not to say it can’t look good but it would have required another order. So I tried what I have now and it worked. It’s a rabbit hole project for sure.