Recent content by JMC3

Hello everyone (especially @jerryb ) I was able to do a full nav delete on my 2007LC with a lot of help from Jerry. It has been amazing, but my truck has 235K and I have the opportunity to buy a 2006 with 92k. When I did the nav delete a few years ago, I recall that I ended up doing some...

Hey guys, I have purchased everything I need for the nav delete on my 2007 LC except for the integration assembly 84014-60350. This part has been discontinued and there aren’t any available through Toyota USA. I don’t know how to source one, but I am willing to pay or go to great lengths...

Hello everyone. I have read the whole thread and am blown away with this creative solution. Thanks to everyone. I want to do the Nav Delete on my 2007 LC. I am placing an order for all of the parts listed in post #1. It appears the brackets aren't available (so I am looking for those)...

OK. Thanks @suprarx7nut ! So I use the adjusted numbers for fine tuning? Pressures are a bit high and the variance L/R is a little too much. My remedy seems to be a couple of cranks on the left TB. Does that sound right? and thanks a bunch for the cheat sheet you produced. Very helpful!

Thanks @suprarx7nut. All of my height sensor readings are low. I would expect them to be at/near zero. Then there are “height adjust“ readings and sensor readings “after adjust”. I don’t think I have seen this before. What does this mean? Do I have something set incorrectly That needs to...

@PADDO @uHu @Indo cruise (and anyone else)Why am I getting these height adjustments and adjusted readings? I haven't seen them in printouts form other guys. I've installed new globes, new sensors and new springs. Heights are perfect at 19 3/4 and 20 1/2. Thoughts?

@uHu, I think you are correct. Something is not quite right with the sensor readings. I would expect FL and FR to average to 0. But they're all low. Weird. Truck is riding nicely. I will review heights sporadically over the next few days and see if the N resting heights are moving around...

I suppose I can dig into the sensor I could dig in and test/clean all of the sensors or simply replace them, but it strikes me as strange that all 3 are out of whack. I suppose its possible....

@uHu the readings are consistent. I haven't waited and exceptional amount of time at low. Typically 5 or 10 secs I guess.....

I didn’t. Am I supposed to manually adjust them to zero? I did a multimeter check on the front sensors and everything seems ok. I don’t remember reading from @PADDO, @uHu, @IndroCruise, @PabloCruise or the rest of you gurus that I should manually adjust the height sensors to zero once...

I am providing a quick update with a follow up question. I hope I am not driving you all crazy with this. I am grateful to this forum and all participants. I replaced all 4 accumulator globes. Did a full @PADDO flush/bleed and did a full rundown for Neutral Pressure test. Cross level is...

OK Guys (and thanks again @IndroCruise ) I still feels like I have no suspension at all. I went through the overall AHC/Neutral Pressure process this afternoon. Here is what found out, but I didn't do any fine tuning of the neutral pressures with Torsion bars. 1. Heights are close -FL 19...

Thanks a million. I appreciate the help. Makes perfect sense. I think I’ve got a bad globe on the PS Rear. But that may be the smaller problem. I think you are correct that I have sensor issues.....

Hi all. thanks To all, especially @PADDO @uHu and @IndroCruise I have read all of the forum front to back and I think I am doing the right things, but I still have a very harsh ride - particularly in the rear. I have a quick question: should brand new fluid be foamy when bleeding the PS rear...

Thanks a bunch fijck! Ordered from Trail-Tailor.