Recent content by JHZR2

  1. J

    1FZ Power Steering issues

    Was there ever a resolution to getting the air out from this bypass? Or was it a failed pump? Dealing with a leaking paper clip, and need to bypass it to be able to do anything else. But the photo in OP does look slightly different because it’s a RHD I think. So the line must be much longer...
  2. J

    A343F transmission pan stripped drain plug repair options?

    The threads may be galled to the bolt and ripped out. They never saw 16ft-lb when tightening when they failed fwiw. I’ll check that thread. Thanks. I had seen a few with failed pans but no good resolution.
  3. J

    help with loose bolt

    Thanks. Yeah I didn’t look close enough at the photo. I thought it was partially threaded into something on the end in the photo.
  4. J

    help with loose bolt

    Ok so it wasn’t physically traced back to its source then… Assuming it is legit and supposed to be there, the surfaces should still be cleaned and the connection bolted tight so it can do its job properly.
  5. J

    Power steering cooler leak

    We are trying to track this down too. When you say paper clip, I assume you mean this: Sorry for the incomplete picture. Note the active leak behind it. Went from damp yesterday night to actively dripping this am when backing the rig up. Still need to track this down more, but what else...
  6. J

    help with loose bolt

    What’s to know? The bolt looks loose, it is a ground I’d say. I saw a few like this on my brother’s 96. Did you chase it back? I’d unbolt, clean everything to bright, re-install, and consider coating with dielectric grease or fluid film.
  7. J

    New user working on a 96 LX450

    Yeah this forum is great. I generally mess with old Mercedes diesels. This Land Cruiser isn’t mine, I’m just helping to work on it for fun. It sure is leaky!
  8. J

    A343F transmission pan stripped drain plug repair options?

    We are baselining a new 176k mile 1996 LX450. Last weekend we dropped the pan and replaced the filter. Overall looked pretty good, though there was some metallic bits on there. Because the pan drop only gets maybe half the fluid. The intent was to drain and fill this weekend. The drain...
  9. J

    New user working on a 96 LX450

    Of course! Been searching for stuff we’ve needed for a while!
  10. J

    New user working on a 96 LX450

    Putting up the introductory post, as I’m helping my brother baseline his new 1996 LX450. It has 176k miles, is very clean/rust free, so it’s a matter of replacing fluids, cleaning the thing, making everything work, figuring what doesn’t, then remediating. So far it has been a process of most...
Back
Top Bottom