Recent content by JDennison

I do not have the FSM, what type of cleaner would you suggest use on the connector? If I recall correctly there is some gunk on the metal connectors in the male plug. And like I said on the AFM, it was rich being programmed for a v6 camry, so I popped the cap off and adjusted the gear(it was so...

How far back should I check the wiring? And I atrempted to look for the best positioning for the tps and i mainly saw recomendations for dead center both screws, and that was the way I installed the new one

It could be that, I can take a closer look. Origionally when I came to a stop my idle would mess up like it was starving for fuel and found that a 93 toyota camry mass air meter fits and is a direct swap for the cruiser. I purchased a reman off rock auto, meter was exremely rich, pupped the top...

Is there a way to do away with that tube or delete it? Would there be any effects on the engine with that cracked hose? I already have the egr "redneck deleted", and havnt seen anything on deleting that portion of the emissions

What is the "S" hose comming out of the air filter housing, attaches to the left of the engine? There is a crack in the end/engine side of it. Noticed that earlier

The intake tube was a new one off a parts vehicle I visited. Looks to be about a year according to the guys paper work. I sanded the contacts down in the fuel pump relay due to heavy pitting, my idle air valve was malfunctioning so i bought a part off the donor vehicle as well which solved the...

A wire could of possibly shorted/popped/arced. And/or melted a wire to where it is now grounding out. If you had issues with the stock seats, the previous owner could of put a fuse in the wire, or an aftermarket breaker

If you have a donor vehicle swap out the idle air sensor. Sounds like an issue I encountered. Make sure your mass airflow meter is hooked in fully as well

2 main issues is occasionally it will stall out, ive had it stall cold and after its been running for a while. Also today driving at about 60mph 2200rpm, the rpms drop randomly to about 1900 rpm, press the gas a little more and it pops back up to 2k/2200, dont really know how to describe it...

I have a 94 Land Cruiser that will run good but as soon as it is at running temp the rpm will surge real low and jump back and forth. It just recently started getting low enough to where it just stalls/dies. I first thought it was the mass air meter so I put a reman in and tuned it a tad(it was...

Sorry for the long spacing of any updates, was recently changed to night shift at the sheriffs dept so Ive been attempting to adjust. I have a throttlw cable comming in, I cleaned the idle control valve and housing, cleaned the MAF sensor, amd wanted to add that it will not crank/run with the...

Where is the best place to buy vaccum lines? Im not familiar if Advance auto carries them or not. Also, did you change the pcv valve out or clean it?

How do you clean the cable? When ive looked it up I usually see people just put lube on the cable. Also I do have the TB on my list to look and clean. Also, would the tps be a possible issue? I havnt heard alot about TPS issues in cruisers How do you clean the cable? When ive looked it up I...

Hey! I am a new Land cruiser owner, engine is an I6, the issue Im having is it takes 2 or 3 times to start(plugs and wires put in 1k miles ago). Once started on cold mornings I have to push the pedal down about 3/4 of the way down to get any response. Once the engine warms I have no issues. If...