Recent content by jdayment

Sorry for your loss out pups are the most important things in our lives.

Going to go with drawers so just doesn't fit with my schema I will probably pick up a set for the 100 though. AZ is great work has taken up to much of my time but hope to take some time over the inter ti explore. We miss WNC.

Bump $150 obo

Orangeboxx Fab MOLLE Panels for 80 series I have them up on the main classifieds as well. $150 obo for local sale.

Selling the set for $175 shipped obo

If you arrange it I can put it on a pallet and drop it off at your shipping company of choice

Going a different direction on my front end so selling my ARB. It is the Non-Winch version however I had it cut out to take a winch and use a winch plate between the rails. Selling for $400 obo no rust one wing is slightly bent but you cannot really tell. I will get some pictures up shortly.

Engine wiring harness?

So I found some more corrosion further down in the wiring harness after pulling sensors and ohming the tps wasn't able to identify a figure until I started moving the harness and had the neighbor watch the CEL I'll pull the whole harness and tear it apart to show the Carnage lots of corrosion...

When you turn the key to the on position do you get a CEL?

Thank you for the guidance it won't be until the weekend I get to it but this helps me a ton! I will update the thread once I have some more data.

So I replaced one of my cats a couple of weeks ago and went to start the rig no luck and no CEL. I went through normal things EFI relay and fuse swapped out the fusible link for good measure still no luck. Thought I would just try and move around the wiring harness and low and behold jiggled it...

Been going down a rabbit whole of wiring issues. Started these today.

I had a similar situation with an IPF light switch they sent me a 35 dollar switch for free even though I purchased the light over 5 years ago

If it's still available I'll take it