Recent content by Jbar93

  1. Jbar93

    Brake issues

    It is a 7/70. Checked the adjustment. I'm pointing blame on the master cylinder right now hoping that a rebuild will fix the problem.
  2. Jbar93

    Brake issues

    I have a 7/70 model. I checked the cups they are put in the correct way. The slaves were rebuilt. And the springs were in the right way. I finally took the master off and took it apart. Found some sludge in it so I have it pulled apart and I'm waiting on a rebuild kit for it as well crossing my...
  3. Jbar93

    Brake issues

    I can take them all apart again. But what are the odds that I only messed up on the two front wheels? I'm pretty sure I got them together correctly but it never hurts to double check I suppose. Iv put several hours in trying to get them right.
  4. Jbar93

    Brake issues

    Could a master cylinder rebuild possible solve the issue if it's got a bad valve? Is there any way of testing to see what's going on?
  5. Jbar93

    Brake issues

    I'll try and see if it's out of adjustment. I have no idea what's going on with them anymore.
  6. Jbar93

    Brake issues

    I'm working on a friend's 1970 FJ40. I've replaced the front and rear wheel cylinders. So all 8 wheel cylinders have been replaced. I blew out the lines while I had it apart and made certain all the air was out of the lines. Now when you go for a drive the front brakes get stuck on and lock the...
  7. Jbar93

    Oil Pressure

    I know that much. Thankfully it's not my first rodeo. The thing is the distributor caught the gear perfectly fine. And then slip past a little bit more and I figured it must have met with the oil pump. I'll do that first thing in the morning. I take it the rotation in the pump is going to be...
  8. Jbar93

    Oil Pressure

    Wire is attached to the sending unit checked that and cleaned the contact point. I can hear valve train noise pretty bad and I've got no pressure on my aftermarket gauge
  9. Jbar93

    Oil Pressure

    Replaced the distributor on my bosses cruiser. I had oil pressure for a few seconds and then lost it. Obviously it's not a coincidence that I replace one thing and loose another. So I'm wondering where to start on this thing to see what happened. It's a 1970 FJ40 land cruiser with a 236...
Back
Top Bottom