Recent content by JacobsBarn80

Here is the old and new parts Old pressure plate: Old flywheel New flywheel (it was cleaned very well prior to clutch being installed) Then clutch and pressure plate were installed and put it all back together. What a pain to get the transmission out and back in!

Hey mate, so I put in a new clutch and got my flywheel machine and seems to be better now. Run-off for the flywheel when installed was like 0.8.mm which is at the upper end of what I would like but not the end of the world. Could also be bad measurements case it wasn't optimal the way I did it...

Hey all, it hasn't helped, ill grab a new clutch and update you on how I go. Ill see if I can get any more info on the clutch compatibility

Hi all, I was just looking at my clutch order and it looks like I might have gotten the wrong one. I ordered the 4T1209NHD and it said it would if on the website but I looks like that is for the 1995 onwards. I think I need the 4T1141NHD for the 1993. Not to sure what the difference is... if...

Hey mate, input shaft had a bit of grease on it but only a tiny bit (no globs) I installed flywheel as per fsm with oil on the bolts but everything was thoroughly cleaned before install. Maybe I touched it a bit while installing it by accident. I have a feeling you might be correct and a new...

I put a new slave and master in today, ill update you on how it goes through the week. So far it seemed a bit better when going for a drive but it was still a bit average. Ill let you know how I go

Sorry for the late reply, still having the issue. I've just been putting it off and it hasn't gotten better. Currently my plan is to replace the master and slave cylinder, though technically they shouldn't cause it, I know my master isn't the best so might as well.... otherwise ill need to buy...

BIt of an update, still having the issues. Potentially looks like one of the fingers might be bent inwards which could be causing it. Anyone know a good tansmission jack avaliable in AUS cant seem to find many

Ill see if i can get some time before chistmas to post something. Mine is more of a shuddering when going taking off more than that chatter.

This is exactly what im hoping i didnt do.... though does seem possible. Ill let you know how it goes once i get that camera, this is exactly the thread i was looking for tho!

Hey jpoole! I did clean the flywheel and pressure plate pretty well.. not the clutch disc itself if that matters. Whats your thoughts on master and slave cylinders/ air in lines. Did a good amount of forum searching and found a couple cases of that causing chatter... might be best to replace anyway

Thanks for the insight, i might sanity check the mounts just to make sure haha. Wasnt much force i did nees to pull together with bolt, did it in a crossing pattern and changed bots if i felt resistance. Done around 400km on it atm but ill leave it alone for a bit longer.

Hey all, Ive just finished a rebuild which is in another thread ill update soon to finish it off. Everything is going well with the engine exept the clutch is shuddering. Does it when taking off, down shifting and reverse. Its got a new 4terrain clutch, throwout, pressure plate, pilot bearing...

Another update, got the piston rings gapped and pistons installed. Main bearings were good at 0.05mm Thrust was good at 0.08mm My crank was cleaned and lashed by the machine shop but is seems like there is an issue with my con rod caps. After new bearings were installed the plastiguage is...

Update! Running with the valves happy with how they are. Valve clearences have been checked, all are good or at the limits. Only out out is an intake which is 0.127 which is a but out let me know what tou think. Im not to worried about it :)