Recent content by jabajee

Here's my setup after Nav delete: Teyes CC3 Amp - JL Audio XD700/5v2 Front - JL Audio C2-600 Rear - JL Audio C1-400x Sub - Kicker 8" 48CWRT84 - I modified the speaker box to accept an 8" plastic spacer and sealed it. Tight but fits. a bit more thump, but not enough that I'd recommend. Needs...

I would 100% by an early access unit!

Thanks, guys. Painted it and will hit it with marine grease before reassembly.

I'm in the middle of replacing my front wheel bearings, rotors, and pads on my 04 LX. Noticed the dust shield / K seal was looking crusty. Pulled it off to find some rust + heavy pitting in a couple areas. I filed it a bit and wire wheeled. Thoughts on a fix vs. having to buy a new...

I'd definitely be in for a 2004 as well.

It's working now. I haven't had any issues, but not sure I've "fixed it". I did replace my AGM battery that went bad after 16 months. Once I did that, I haven't had an issue. I know some electrical weirdness can happen with a failing battery, but I never thought about that being the real...

Picking up my '25 LC/LC tomorrow. Premium package. Traildust color. -$5200 off of MSRP. No crazy dealer add ons. Options: 20"wheels(lame), Carpet floor and Cargo mats (they are throwing in all weather), illuminated door sills, and ppf.

Thanks, @jerryb. I took a look at mine yesterday. Looked pretty clean. May order a new one and see where that gets me. I've already replaced the blower relay in the fuse box, blower resistor, and a new blower fan. Still intermittent issues. There has to be a short or something somewhere...

Thanks @jerryb . I wasn't sure what was being referenced above the piece you are mentioning, or the block of relays/wiring inside the under hood fuse box. I got a brand new fuse box unit from Lexus, but it doesn't include the section w/ all the relays/wiring which is my worry. I'll start with...

@jerryb @greenmachine93 - Can any of you help me out with where/how the loose connection on the fuseable link could be fixed? I'm having this same issue. replaced resistor 2x. I've had luck with it running for a couple months with no issues, but now it's back. it will kick on for a few...

I've been having intermittent issues with my fan blower for almost a year. It does not consistently work. Sometimes it works for a few days, sometimes it kicks on and off several times during a drive. It's starting to drive me a bit insane. Here's what I've done to troubleshoot/fix so far...

I just did this on my '04 this week. Noticed AHC fluid leak under driver's side front. Researched a ton on here and narrowed down to O Ring or corroded top of "shock". I quickly found the culprit after I removed the shock. Some AHC fluid shot out at angle that it shouldn't. Yours looks...

@selaxe - THANK YOU! Lifesaver! I have been troubleshooting the P0102 + Limp mode issue forever. assumed it had to do with my melted O2 sensor connector harness/wiring. fixed that and couldn't figure it out wth was going on. Checked the first 10 AMP fuse and boom. limp mode gone...

I wonder if your issues would go away if you used an aftermarket amp? My levinson unit was trash, so I swapped it out. Mine is 2004 though. Just a thought. Mine is working flawlessly now.

It was the CANBUS settings. They were null. worked immediately. So far so good. Need to hook up the backup camera still but that's it.