Recent content by J Mack

Sorry I sent off my only spare gear I had here.. I think the 3D print file is out there if you have someone that can print one for you.

Yeah butt ... If I used that to justify carrying a full sized spare tire then my pig would be 8000# packed with all the spares that "might" be needed at some point.. 🤣🤔🐖👈🏻

Tire plugs and a portable air compressor will fit under your seat and will get used way more often than putting on your spare..

I still haven't perfected the two color printing but it is getting closer..

30 miles +/- after I first noticed I was having an issue.. Just took the back roads and resisted the urge to pass slower cars or pop wheelies.

Yes...

Carbon chassis is done. Tried to print the hood two tone blue and white and completely jammed up my printer, ordered some different filament and I'll try again later..

Making all the titanium links and test fitting everything on a 3D printed chassis.. Still waiting on a few parts to finish the cantilever rear shocks then I should be able to break this down and start cutting carbon fiber..

A lot going on in a pig doing anything over the speed limit and the hood "weird floaty thing" almost disappears when you start focusing on all the other ways you're about to die. Fortunately I have the under/over drive gears in my transfer case and the gear whine at 95 lets me know I'm going...

Well at 95 MPH passing a few slower cars I started to smell something hot and developed a vibration.... U-Joint must have been glowing red hot for a minute until we got it slowed down and limped it home...

Slowly getting back around to this.. I had a guy that was going to help me with the 3D printing version of this and unfortunately he faded. I ended up buying a 3D printer and spending the time to learn the process. Finally getting to the point where I can start making angry pig body panels.

So are you planning on a RTT to knock over the hotel signs?

Rightfully so.. Rear wheel arches and lower rockers appear to be made from body filler...