I should have clarified I have already removed the head from my engine. This started off as a head gasket replacement and grew into this monstrosity of just replacing the entire engine. So in the truck right now is the short block which was why I was looking for ways to remove the short block on...
I was thinking about this but I'm worried about reaching the top trans bolts with the long block assembled. Maybe it wouldn't be too bad.
I'm curious, you mentioned going back in with the long block but I was just curious why you suggest this? Is there a significant advantage of going back in...
That's what I thought when I purchased it as well. I thought I was landing a steal of a deal but the PO blew the head gasket and literally chose to do everything wrong
That's sort of what I was thinking and then I could just drop the new short block back in, tighten the trans bolts and then...
Nice!! When you pulled your old engine did you pull it per the FSM or did you happen to pull just the short block. I ask because I'm at the point where I think I would like to just buy a new short block but I have already removed the head so I'm curious what the best course of action would be to...
Hi, I have tried searching for a write up on this but I can't seem to find one. I am currently working on a '97 with 125k miles. One previous owner who took great care of the cruiser itself (body) but the engine has been a nightmare. My question is, has anyone pulled the short block from their...
Well I actually went ahead and bought an entirely new OEM head and all the parts that go with it (springs retainers valves). I just don't want to put all that new stuff on a rusty short block if it's been abused :/
No I can't feel anything with my fingernail. It feels uniform with the rest of the cylinder wall. It has been taken apart previously by a "shadetree mechanic" as the machine shop guy put so maybe they ran a hone through it?
I just want to start off by mentioning that I have read through @Jorgito super thorough and helpful head gasket post from a while back. I also have the FSM and OTRAMM videos for reference.
A little back story (kind of lengthy but please stay with me because I need help), I purchased this 125k...
Hi, I don't want to revive or hijack a very thorough thread but I am in the same boat as Jorgito working on my '97 40th anniversary 125k miles. I am a noob, most I have done up to this point is front main seal and oil pump and have been using this thread paired with the FSM and OTRAM to get to...
Will likely be throwing a new head at my 1997 soon. You mentioned the OEM head came with the valve seats and guides in place. Do you happen to remember what wasn't included on the new head that you couldn't or didn't opt to harvest from the old head? I plan to go new for the valves and springs...
That was my thought as well. And if redecking is necessary to complete valve job, it seems like he could've presented the idea of cutting new valves when he noticed the pitting rather proceeding with everything and then waiting until I went to pick the head up to mention both the pitting and his...
I would like to have a valve job done given the points @Fj80oregon mentioned are associated with a new factory head install. One of my biggest concerns is that the guy at the machine shop mentioned he would need to deck the head once again after he cut new valve seats. This concerns me because...