Recent content by Indefinite

What is the Part number for this part? Or where can I get it?

I have always wondered that. I work in the boat building industry, sika and plexus basically rips the composite apart. Wonder if anyone has tried?

Hi ya, got my 1977 original sideview mirrors powder coated, now re assembling. One thing I noticed, the bushing sits up now off the housing, is this the correct install? Seems to me, it could be installed with the flange inside. Can you guys confirm please?

Team, I do not have a FSM handy, but can you please provide the following for me? 1977 Fj40 2F engine 1. Fan to Fan Clutch Nuts 2. Fan Clutch Assembly to Water Pump 3. Thermostat Upper Housing 4. Water Pump Bolts 5. Thermostat housing to block Thank you guys so much!

Team, Got some new steelies and dropped them off at the powdercoaters. Matching them to T450 Toyota Grey paint from cruiser corps. Just a heads up, almost a perfect match to RAL 7012 Basalt Grey. Just a heads up, as I know there was discussion on this.

I am down in Loudon if you need anything.

Was just scrolling. Clint @heritage cruisers has a plug and play wiring harness and other components needed to have the ND system as a stand alone for a 40. I just got the box today and it’s awesome! Hit him up

Mark, thank you!

Not leaking from there, checked the whole perimeter No gas in oil. Just major oil leak. I have been checking the oil and no issues there with oil/gas. Just missing gas.

Guys, Need some help, been chasing an oil leak. I thought I had it by replacing the following: -Oil filter housing to block gasket -Fuel pump to block gasket At low speeds (up to 50mph) I have min. oil leak, almost not noticeable. But at fwy speeds, the oil amount that leaks is all over the...

Ok, getting somewhere. Here is what I got, the last item I need to know is number 5. 1. Rear u joint bolts (4) torque spec. 65 ft/lbs 2. Output shaft stake nut (1) torque spec. 80-101 ft/lbs 3. Front u joint bolts (4) torque spec. 54 ft/lbs 4...

Team, I am in process of rebuilding my 5/77 2F transfer case rear output seal and e-brake components. I do not have a FSM handy, was hoping you can help here (see pic). Also, here are the callouts: 1. Rear u joint bolts (4) torque spec 2. Output shaft stake nut (1) torque spec 3. Front u...

This is exactly what I was texting with you about today. Definitely going to do this as well after I dial in parking brake.

Changed oil filter bracket and fuel pump gaskets. Whomever said this takes an hour wasn’t scrapping off the 46 year old gaskets!

he has them, I bought one a few weeks ago