Recent content by Imatsu

Just wanted to post an update. It turned out my AFM was bad. Got a new one and it now starts and stays running.

Ok those are good things to check, will have to do that when I get back from vacation in 4 weeks haha. It sat for probably 6 months so it wouldn't surprise me if something got gummed up

What do you think could be wrong with the fueling system? Anything I should start with?

Hopefully this will load to show what it's doing

Everything is new except a few vacuum lines that were replaced right before I got it

Ok ill check to make sure. I thinknit might be under a little bit of tension

Ill have to check that, I've had to mess with the cable a few times when I got it and I replaced it but I think I may need to tweak it a little more.

It does it back to back. Giving it more throttle might make it try to run for a few more seconds but it constantly dies

It does not. Doesn't matter if it starts on fuel or starting fluid it does the same. Tries to run for a few seconds then it dies

Yup

Gotcha. Ill try that after I get off work today.

I double checked all the wiring and connectors and they are all good, and distributor was lined up as at should but ill check it again for giggles. Its tries to run it's just studders for a couple seconds trying to run then falls on its face and cuts out. I have a short video of what it's doing...

Plug gas is .031. I still gotta check compression, my buddy borrowed my tester and I'm waiting to get it back

Tore it down to the bare block with new bearings and seals/ o-rings, etc. Everything went together just like the fsm, timing marks lined up as they should. Just struggles to start and stay running. Plugs and wires are where they need to be thats the first thing I checked.

I tried posting a video but I wouldn't let me, any suggestions I should try to post the video?