Mate looking like good progress!!
Been meaning to add some photos of my set up as well 2lte
Intake piping jrp 14n1 guage
Wired in potentiometer which seems to help with quicker spool up times with lower revs.
White switches are for winch
Ah figured out my boost problems. Needed to calibrate the boost controller getting about 14psi boost no check engine light.
The idle adjustment on mine is a lock nut with a flat head screwdriver to adjust inside the nut. Near the throttle cable butterfly valve area
I'm getting a wee bit of...
Hey thanks for the reply!
I did pick up this bleeder from another member on the forums so will give this a crack and see how it goes
I did see in a previous forum that for tuning these the boost sensor/map sensor starts to cut fuel after 4volts is achieved any idea what pins the ecu are to...
Been looking through a lot of forums and need a bit of advice on some issues on my 2LTE
I'm struggling at getting over 10psi of boost.
Bit of info on the truck.
1992 ln130 4.88diffs lockright lokka front
33sx12.5x15 2 inch suspension lift
Winch bar
Water to air intercooled dual pass radiator...