Recent content by Hornd

  1. Hornd

    Thermostat Question

    https://www.familyhandyman.com/project/coolant-testing-with-a-multimeter/ I change mine every 5 years and Print a Label. Label Print with "Coolant Changed [Date]" and put it next to fill Neck.
  2. Hornd

    Side view mirror replacement

    Save a search in Ebay. - It will email you every time a Mirror is Listed - Confirm if color matches. My Corolla got Sideswiped and I bought a New Mirror on Ebay, and spray canned it with a Few light Coats of the Factory Tan and it does not catch the Eye. Total cost was ~$50 The car has 300K...
  3. Hornd

    Back in the Game - Added an 2005 GX470 - Toledo Ohio

    The Truck was Pulling a 4x6 Trailer Full......but you 100% Right. I have 5 Cars, 2 Boats, 1 Motorcycle, & 1 Camper and 1 Log Splitter. I'm trying to Avoid any more Registrations/Plates.
  4. Hornd

    Back in the Game - Added an 2005 GX470 - Toledo Ohio

    The Airlift Bags with 35 PSI Air in Valve = No Rear end Squat. *See the Schrader Air Valve Bottom Left Hand Corner Hauled 2 Loads of Maple while towing a 4x6 Trailer....My Back is Sore. Filling the Heat Banks is one of my Favorite Hobbies. These Trucks have a Very Strong Tubular Frame...
  5. Hornd

    Egr delete plates

    Stainless Sheet --> Sharpie --> Angle Grinder with Cut off Wheel. If you do not want to mess then Purchase Plates.
  6. Hornd

    New subframe from toyota - part number differences?

    Dude your in Clvlnd! Go Visit Ethan in Upper Sandusky. He's a Wizard with Frame Repair. https://www.facebook.com/ethan.reddick.2025/
  7. Hornd

    New subframe from toyota - part number differences?

    I'd Bet The Kings of Poke-Yoke prolly only have 1 Frame and the Diameter Change for the Sway bars is Handled by a Bracket.
  8. Hornd

    New subframe from toyota - part number differences?

    With Engine Short Blocks like $8K I figured the Frame would have came in well north of $10K. I had mine Repaired and the Body Mounts are available Direct from Toyota and they were only $75. I found that Very Reasonable.
  9. Hornd

    "Land Cruiser" Floor Mats for 80-Series

    I know you do not want to hear it but this is Superior to OEM, unless your Rig is all OEM (Picture says otherwise). *This will also Protect your OEM Carpet the Best.
  10. Hornd

    Rebuilding a 1999 Jayco Pop Up

    Bought Open Box on Amazon for ~$100. Was Bent on Corner - Straightened with Sheet metal Tools Nice Welded Aluminum Construction is Light and will not Corrode. Installed with 1/4" x 1.5" Metal Bar Welded Across Tongue and Tech Screws Across Front. Permanent Home for Weber Smokey Joe, Charcoal...
  11. Hornd

    Who sleeps in the back and has built a platform?

    Milk Crates will hold a Lot of Stuff and are Just about Perfect Height. Put them on Roof if you want to Sleep Inside. They are also the perfect storage size for a Propane Tank and they stack Nicely.
  12. Hornd

    What Does This Seal Do?

  13. Hornd

    Speaker fitment and info...

    Just bought them for my 05 GX470. Heard Great things and there is a Plug and Play Setup. They have Dual Ohm Voice Coils so the wiring requires an Extra Wire to get to 2 Ohms.
  14. Hornd

    Question about bearing loads in V35A.

    "Drop the 1FZ-FE into 2nd Gear and Leave the RPMs at 4K for Mountain Passes.....They Built for It."
  15. Hornd

    Who sleeps in the back and has built a platform?

    I have 10.5" Tall Drawers in my Cruiser that I Built to Fit. I'd Nap in a $20 Hammock if I was camping. Need to make a set of these that Break Down. Thinking a Triangular Box for Wheel with Post off End.
Back
Top Bottom