I used some self tapping metal screws. I think they were #6. No nut/bolt. I'll keep an eye on it, but the screws seem to hold pretty well. They do recommend a bolt/nut for metal surfaces, but getting that headliner pulled back there is a pain.
Installed the Ironclad Engineering rear quarter panel bracket for the 80 Series LC and got started on installing my auxillary battery and accessory power distribution.
Ordering from Brad at Ironclad was a great experience. Pricing is in AUD. He was quick to contact me with the...
I just received the bracket/mount.
It’s really nice. Highly recommend it if you’re in the market for one. The price is great(especially if you’re paying in USD) and time from order to delivery was just under 4 weeks delivered to New Mexico. Customs in LA accounted for about half a week.
I...
Thanks. Will give that a shot. The headliner seems very firmly attached at the top the rear cargo door. It had me stumped. I was thinking about trying a fish tape down the C pillar.
I have a couple of Scan Strut roof entries and i'd like to run a pair of 10 ga. wires and my 2-way antenna coax through the roof in these. I am not quite sure on pulling down the headliner in the rear cargo area though. I pulled back some trim in the rear door area, but wasn't able to figure out...
I ordered it as well this past week. Brad was quick to follow up with a status on shipping timeline. USD to AUD conversion rate really helped on price.
That's my hang up. Out of NM - so mostly desert ops, but we get up into Colorado too much for me to not worry about deeper stream crossings occasionally. I'm thinking about putting the compressor in the driver side rear quarter panel and a tank in the place soon to be vacated by the spare tire.
My 4x4 Labs rear bumper just came in so I started looking at the install doc. Am I reading correctly that I cut off the exhaust before the resonator - effectively removing the resonator?