Recent content by Gr3G

You can get the Zlink apk from a Google search. You'll have to put it on a USB drive and install it on the unit. Mine got deleted on accident and I had to dig up the apk. https://forum.xda-developers.com/t/zlink-app.4030365/ One of the downloads in that post has the correct one I can't recall...

I have a set. They're not in the best shape. I removed them from my 07 LC because one of the vents was missing the tab for adjustment, and the PO had some stereo shop drill holes in the passenger side one for a line in connection. I pulled all the fake wood out of my interior, one of the pieces...

I have a 2007 Land Cruiser that has intermittent satellite radio issues. Most notably it will decide to quit picking up stations and I will have to turn off the truck, then turn it back on and the issue is usually fixed. Recently it's decided that it doesn't want to even be available, if I press...

If the replacement comes with a sealed bearing it makes me wonder if the failed one had a seal once upon a time. With no seal or solid lubrication in the bearing it's very likely lack of lubrication is what killed the bearing.

Any 6004 sized bearing should fit in that application. OD= 42mm ID (bore)= 20mm Width= 12mm

That figures. I don't know how similar the 100 series starters are to the 80 series starter but I did find a thread that goes a bit more in depth with the starter reman. Might be a fruitless effort though. I can't image the bearings themselves being more than a few dollars each...

Yep, that's a dead bearing. I would think someone like Motion industries or Fastenal or MSC would be able to get that sized bearing from a good manufacturer. (Timken, Koyo, SKF, etc.) All they would need to figure out the part number would be bearing type (single row ball bearing, taper bearing...

For whatever it's worth...I know every situation is different. But I gave $2500 for my 2007 Land Cruiser with 192k. It had a blown head gasket when I bought it. It was a one family vehicle and had good service history. Unfortunately, the original owner gave the truck to his daughter and the...

I ordered a few to replace the seat heaters and the pwr/2nd switches. They didn't come with the green covers. The seat heater switches apparently don't require the covers.

Thank you for the part number for the hazard bulb. I've not had much luck in my searches for that bulb. Does the new one come with the green bulb cover? On another note, are the green bulb covers available from Toyota? For some reason my PWR/2ND switch is not green like the other switches in...

That looks like the harness to one of those external satellite radio tuners. Probably uses one of the lower FM Channels instead of having a dedicated satellite option on the factory head unit.

I just recently went through an engine replacement on my Land Cruiser. I bought it with a blown head gasket and I knew it would need a new engine when I got the truck. It was relatively cheap and even with the engine replaced the money I would have in the truck would be well below any book...

I think those are the same tires that are on my work truck (2015 F-150). They've done well off road at job sites and such. Can't really comment on snow performance, however they have given me zero problems and I have over 100k miles on them. They're due to be replaced whenever work decides to...

Nice information! My 07 Land Cruiser was also missing the tabs on those vents. I lucked up and found the complete left and right side vent assemblies on eBay for $80. I might have to give the parts you listed a go to repair the ones I took out of my truck. I'm sure someone on here probably...

I've had castle nuts stuck on for whatever reason. I've had good luck taking a Dremel tool or die grinder and cutting vertical through one of the notched areas of the nut then taking a small cold chisel and breaking the nut. It may be easier to cut the nut on both sides and split it in half. Not...