Recent content by gotograss

Thanks again, everyone!

Thanks BILT4ME, that’s along the lines of what I was thinking. It was clean when I visited in April. I’m headed from Enid, OK to Missoula, MT but I haven’t decided on which route. Great community, here!

It's been parked in Oklahoma.

Thanks for all the great comments! Unfortunately, I was not smart enough to cap the pipe. Snacks, indeed! I thought about some sort of additive but never had to deal with it before and wasn't sure if would help anything. It is a 1HDT and I don't notice anything off when I've driven it...

I rarely post but I've gotten so much out of this site over the years. Thanks to all the geniuses on here. I've had my '94 JDM 4.2l 80 series for about 15 years but it's been in storage (outdoors) since moving back to the US almost two years ago. I have always kept maintenance up and all the...

Now, if I can only find that low-range sensor...

Thanks for that tip! Maybe I'll run a switch to the cab on the low-range sensor to choose which shift pattern to use. Luckily, I already have a CDL switch. Thanks for all the input, folks.

I vaguely recall something similar but I couldn't find a post anywhere.

In one of the threads I mentioned above, half k cruiser said: "I used to have a link to a Jeep site where a guy installed switches onto his trans solenoids, then he could lock it into 1st or 2nd. The cherokee XJ has a 1-2 selector position rather than 1 and 2, so this was his solution to get...

Thanks for the suggestions.

It is an A442F...

Unfortunately, not mine.

No, it will just start in 1st and not go above 2nd if in "2". Thanks.

Hey team, I have a '94 HDJ81 VX w/ the 442. As you know, I'm lacking the 2nd gear low-range start switch. I've read the other threads I could find: Low range manual gear selection Seriously delayed 1st-2nd shift in low range only but they are pretty old posts and they sort of dropped off before...

Hey team, I'm pulling apart the intake on my '94 80 Series 1HD-T to clean it up and investigate the oil "spray" at the joints. As she has a few years on her, the rubber ends have lost their elasticity. Has anyone had luck rejuvenating those hoses a bit? Belt dressing, Armorall, etc.? Any other...