Recent content by Gilles75

Hey, I have a question related to the H152 gearbox swap. I was wondering if the taller 5th gear ratio can be put in the H150/H151 gearbox? And if so, does anyone know where/how to find the part number of that taller gear please? Thanks!

Hello all, I was advised to post this question in the diesel section. My truck's stall speed is at 1400 rpm. I had the torque converter replaced (with the heavy duty version from Wholesale Automatics) but that didn't change much (except that the shifts are nicer/better now). I have the A442F...

Hello all, anyone have some suggestions on where to look for the issue that I have? The torque converter is all fluid based with no electronics. Is it gearbox or engine related that my car stalls at 1300 rpm (instead of 1900 rpm which is factory specification).

Yes so it seems. But where to look now for the issue? Stall speed at 1300 rpm isn’t correct, right? Any pointers or suggestions are highly appreciated.

I'm coming back to a very old topic but I'm experiencing some issues with the stall speed. My 1HDFT combined with A442F trans stalls at 1400 rpm (this is obviously way before the turbo kicks in and therefore its difficult to climb hills from standstill). I have replaced the torque converter with...

Hello Phil, can you advice me what fuel hoses should be connected to the dual filler neck? I an installing my sub tank as well but it seems that the filler neck has a diameter of 42.6mm which is an odd size? Did you use the original Toyota fuel hose and if yes what is the part number? Thanks...

Hello all, I have a 1995 1HDFT automatic Land Cruiser. Great car but I do have an issue with the low stall rpm because it makes it hard to climb a hill from standstill as the engine does not rev up above the stall rpm (which is way before the turbo kicks in). I bought a new torque converter...