Thank you! I’ve been doing rattle can work for at least 40 years so I’m very comfortable with the process and totally agree with the ability to touch up as needed very easily!
Sure. Mine were not chipped or worn through. The original paint or finish was stained from wear but not corroded. So a thorough cleaning with suds.lab zero acid wheel cleaner followed by thorough cleaning with Dawn dish soap.
Then a light sanding with 400 grit wet paper and finally 600 grit...
Just restored my OEM wheels and wanted to share what I used as well as a few pics. I don’t think keeping stock wheels is super popular but it’s what I wanted to do. Hope the paint/color (SP188 -color) info is helpful to someone wanting to do the same. And new KO3 tires installed too. Always...
Just replaced yesterday. 2001>268k.
Started and heard what could easily be considered a radio whine immediately. Hmmm. Increased rpm and seemed to go away. At low idle back. My shop happens to be 1 mile away. They heard it too. Two things. It still measured 14.1v but at low idle the voltage...
Yeah it’s a single pin connector on a gray wire. Could be part of the afternoon Kenwood head unit install (prior to me). It doesn’t have gps. Thank you!
Just finished stitching mine. Great product! A few tips;
1.) take your time. I think I took a couple of breaks and all in it was about 2 hours.
2.) watch the YouTube video of theirs. The instruction sheet they send is pretty good.
3.) make sure you remove ALL of the backing of the double back...