I want to thank everyone for their input but I think, I F . . .ed up. The input shaft as stated by an earlier poster will not mate to my 2B diesel and I see no way to make that happen so I am back to square one.
Live, fail, and learn
Thanks.
That says it all, he is parting out a jeep. You got the wrong vehicle.
Ha. ha. ha. . . . I have so much invested my beast if I started over my wife would kill me.
The guy I got the split TC from is parting out the jeep (He rolled it) and has the hand brake assembly that connects to the rear axle. I am trying to get it and will let you know how it goes.
Really appreciate the input.
Will the input shaft out of the older Tranny fit into the new one? Or will the Spilt transfer case mate to my old tranny. I had the old tranny rebuilt about two years ago and it works fine.
Many thanks. . . .
I am in need of some installation instructions to install a 1981 split type transfer case and tranny to replace my TC & Tranny in my 1975 2b motor FJ40. My mechanic, while more than competent is hesitant to dive in without some details. I am too old do it myself, so if any of you guys can give...
I live in the Philippines and have a 75' FJ which had a 2B installed in the 90's. I bought it four years ago and had a restoration done. Everything but the engine. which my mechanic says had been recently rebuilt and runs great but is totally gutless. I had thought of buying a 1HZ-TE or...
I live in the Philippines and have a 75' FJ which had a 2B installed in the 90's. I bought it four years ago and had a restoration done to it. Everything but the engine. which my mechanic says had been recently rebuilt and runs great but is totally gutless. I had thought of buying a 1HZ-TE or...
My tranny was noisy so I had it rebuilt (bearings and seals only. It was still a little noisy so I used Mag synthetic gear oil and WOW . . . you would not believe it reduced the noise perceptibly and shifted a lot smoother. Worth the extra expense.
I had a whine in 3rd and 4th gears, bought a TT bearing rebuild kit for my four-speed, but it turned out it was the Transfer case input shaft was shot. Bought the bearing kit for that and wow like both are like new--smooth and no noise.
1975 BJ40