Recent content by FlyingRN

Recommendations for a good quality air pressure gauge? I'd like to replace mine. I carry one in each of my vehicles, so I'd like to buy several. Probably would prefer an analog that holds pressure but am open to digital suggestions too.

Still available, offers considered.

Bump

These are still available.

I had to use two of the center caps for my front wheels. I also have another full set of stock wheels with no tires, I'm not sure if they have center caps on them or not, I'll have to check.

I have a pair of grey power leather front seats for a 100 series. Some wear on seats, but come with relatively new gray leather slip over covers. Open to offers.

4 -2002 100 series factory wheels with 2 yr old less than 5k miles on tires. No plugs, holes, flat spots etc. Pathfinder All Terrain 265/75 16. I travel to Orlando often, delivery options available. $500

My mistake, no they are the factory 16"🫤

I've got 4 stock wheels in Daytona Beach area.

I ordered mine off of Amazon, Shipped from "Clauss Studios" frim Ricochet polyurethane technologies for $44 (did NOT come with the required lube)

Thanks for the tips! I filed a small amount of the leading edge to get it to center itself a little better (like a 1/16th") and was able to get it to start. Had to stop and go the the hardware store to buy a longer bolt and washer to act as a "puller" to squeeze it all together. I'll be...

OK, Problem here, apparently I have the earlier style larger bushings because my new ones don't fit (they're too small) Any recommendations on where to get the proper ones?

I'm not sure why everyone says these bushings are hard to get out.... Mine fell out. 🤣🤣🤣

Luckily I'm in a position where I don't have to sell the 4Runner, that's my daily, the LC will be a fun toy. 😀👍