I thought I had replied on this thread with an update on my 4.56s, I see now that I never did.
I have a prior post after regearing to 4.56s with an H55F in my FJ62 w/ 3FE.
@goped I imagine H42 with 33s and 4.56s would be a bit over 3k rpm and keep you off the highways. I was at 2900 with an...
Wasn’t bad at all, probably about 2 hours of work for me the other day.
Work on taking the pitman off first and it’s all easy from there. Hitting the bend in the arm while using tension with the puller vibrated it loose nicely.
I kept my wheels set straight before pulling the old box and...
Great video. Picked up a few good tips and installed my 80-series box without issue.
For the pitman arm (had to remove two), I used a cheap two jaw pitman arm puller, put a little heat on the outer ring of the arm. I kept some tension using the puller and hit with 2-pound hammer repeatedly...
I just completed 4.56s in my FJ62 w/ H55. I’m also running 33’s, Mastercraft 255/85/16s.
I’ve been running the H55 for 3 years and a few trips from Texas to Colorado. In my opinion the 4.11s have been great for highway cruiser across the plains of SE Texas but wanted to change ratios while...
Appreciate the response. I’m going to checkout the Drilled Head Bolt company and see what they got. I like the idea of having a hardier bolt there.
It took a bit for me to accept keeping the drum brakes for now and then realizing how small these bolts are almost feels like a little too much.
Found this thread after landing in the same boat. Any luck on a source for these bolts? I have one broken one and found they are NLA
Interested in what you ended up doing?
Great FJ62 you have there, you’ve done a lot of incredible work in a short time.
I would begin considering the possibility of a slight head gasket leak or valve seals allowing just enough blow-by for combustion gases to condense water out in the oil, and decide how you want to approach from...