Recent content by FJ40mod

Wasn’t going to clear without removing the bib. I really wanted to avoid it since my rig has the added benefit of Air Conditioning.

Ok folks, I’m looking to find out if anyone knows of the 2F can be removed by the Chinese engine hoists without sheet metal removal. As a data point, mine has a 4” suspension lift and 33” tires. I do not plan to pull with the transmission attached. Thanks in advance.

For posterity, on my early 1973, the power feed to the washer pump comes out of the main harness right near the fuse block.

To answer my own question: yes there is more than enough clearance without a body lift for a 3" filter element in a Downey, on a Holley. Could run an additional 1/2" spacer depending on orientation preferred for the air filter. If the studs for the windshield bumpers on the hood have their...

This sounds great. I have plenty to keep me busy until then. Rear axle seals and brakes are this evening's project.

I’m sure it’s just a simple matter of wording. When I say physical location, I mean a specific point where a physical thing is located. “Under the dash,” is simply not a physical location so much as a general area. An area that I have described is not easily accessible. If someone...

Thanks for all the input guys, but I really just need to know where the pump power physically connects to the feed shared by the motor. I have AC in the truck and someone put aftermarket gauges in it, and covered the factory hole in the dash in the process. There is no room to be physically...

Yes, the wiring diagrams are how I was able to figure out what i described in the post. Unfortunately, the diagrams don’t give the information of which I am in need.

Thanks Charlie. I’m trying to find out where the power wire to the pump physically connects to the power circuit.

Yes, I have my wipers working and cleaned up the ground contact at the switch. I have switched ground at the pump, but no power.

So, I have successfully resolved the predominance of the rig’s Electrical gremlins. Only the aftermarket gauges messes and the washer system remains. I do not have power to the pump. Where, physically, does that power wire feed from the fuse box? Is it it’s own separate conductor from the...

Is there room under the hood for a Downey air cleaner for the Holley swapped carburetor, to use a 3” tall air filter?

Unfortunately, or fortunately, no backup light. Right now I would call it one less thing to get working.

With pic

Teaser photos… Does that distributor cap help narrow down what distributor might have been slammed in the hole? The PO didn’t put it in but told me he was having a hard time finding a cap. I have quite a few parts to track down. This cap and/or distributor though, it’s been too long since...