Recent content by fixitdude74

  1. fixitdude74

    LANDTANK - SUPERCHARGER

    The great lord humungus!
  2. fixitdude74

    Australia 1fz-fe owners, exhaust system, catalytic converters

    Australian delivered 80 series cruisers don't have catalytic converters, they were implemented in the next model (100/105 series).
  3. fixitdude74

    Registry 80 Series Registry

    it's a thing of beauty! i am in awe
  4. fixitdude74

    Has anyone advanced the timing on 1FZ-FE?

    I experimented with different degrees of initial advance and used my electronic stethiscope to listen in on knock, i found whilst running 91 octane(opal fuel) and anything from 6-12° of advance the engine did not ping, but soon as i went over 13° it would ping, then the ecu retarded the timing...
  5. fixitdude74

    LANDTANK - SUPERCHARGER

    "Greetings from the Humungus......the Lord Humungus" !!
  6. fixitdude74

    Registry 80 Series Registry

    1. Make an Model - 1997 Toyota FZJ80R-GNPNKQ 40th Anniversery Commerative Edition, 4sp auto 2. Owner = Fixitdude74 3. Name = Goldy 4. Mileage 269037 (432974km) 5. Mods = Bullbar(ironman), new engine @432201km(1FZFE), GME TX4500S, VMS700, IGNITE 160W lightbar, Narva freeform headlights, 2" lift...
  7. fixitdude74

    Fuel tank pickup coating

    May i ask ( as i am doing the same to my 80 ), did you have to extended the tank securing straps to fit around the prado sub tank, or did your old 80 ones fit? Also, is the prado gauge resistance the same value as the 80 sub tank level gauge?
  8. fixitdude74

    FAQ How-To: TechStream In 5 Minutes

    Does this work with the FZJ80? bear in mind not all 80's had an obd connector, some only had the toyota DLC under the hood on near the firewall, which would require a obd to 17pin adaptor cable. I'm trying to establish whether this will work before i go out and spend more $$ on $hit that doesn't...
  9. fixitdude74

    Adjusting Valves on 1FZ ??

    I know this is old thread, I have just done my valves, and the only reason i did is the previous owner had a new head fitted and the mech didn't put the correct shims in, so i researched, bought the special tools for compressing the valve lifters and the other tool for holding the lifter whilsts...
Back
Top Bottom