Recent content by fastbee

I tried to reposition, basically no movement. The standoff seems to work so I'm leaving it. I siliconed a very small crack I found like you said.

Like I said before, I don't want the sunroof to work. I'd rather it be gone. Definitely not interested in tearing it apart to try to fix it. I do maintain the drains and trough, which is how I found the sagging glass. No hate for the guys who think they need a working sunroof but I'm not one...

I might have found a solution. It definitely looks better from the outside. I got some M6 circuit board standoffs (https://www.amazon.com/dp/B09W61R31H?tag=ihco-20) from Amazon. The 10mm tall one worked pretty good when installed on the rear stud. By using the standoff I was able to space up the...

I've watched that video before. Mine is fully seized and I'm not looking to make it work again. Was just curious if anyone had this happen before and how they fixed it. It almost looked like if I could get it to slide forward a little it would tip the back up some but I can't get anything to...

Today I was preparing to clean my sunroof drains due to getting a little drip during the last rain spell. I usually just give a courtesy glance at the outside before removing the glass and found what might be my main problem. It seems the back of the sunroof is sitting so low they the seal isn't...

Any one ever dealt with recurring P0420/P0430 codes that cleared when towing? On the weekends when I tow my boat the codes will clear on their own but through the week they seem to come back. If I leave them they'll go away the following weekend assuming I get to fish but by Tuesday at the...

I bought a Rhino Radio. I got the latest one they had for the 100 series. I really like it but be aware that while the installation was plug and play there were some things to fiddle with. I ended up removing Android Auto as well as the voice command apps due to strange issues that popped up...

Thanks! I thought I read something about those wires. I'll probably just junk all the stuff I pull out. Might see if there is any interest in one of the Facebook groups but don't want to put much effort into selling it.

I'm going to remove the CD changer from the center console of my 03 LC. Probably get something from Ben3d to replace it. Also plan to remove the Navigation drive under the passenger seat. Couple of questions: Is there a market for these parts? Do I need to do any wiring to keep everything else...

Noticed today while fiddling with a new OBD2 adapter that my throttle position % shows ~14-15% with the vehicle not running. I started it up and it stays the same, no throttle input and ~14+% shows at idle. Anyone else have something similar? It runs fine but does idle higher than any of my...

Thanks for all the info 2001LC! I'm probably due for a flush based on time according to my service history. I'm still getting my bearings on this vehicle. I love it, but getting everything caught up and backon schedule seems never ending!

According to the service history they have been changed. The tees are still shiny and black and the hoses look good but that's a good thought on where I might be slowly loosing some coolant. I'll put it on the list...

I didn't have any manuals until about 10 minutes ago... Looks like I need the Long Life red coolant.

What is the correct coolant for my 2003 LC? While investigating weeping PS hoses (where are folks getting the 3/8 and 5/8 hoses BTW?) I noticed my coolant bottle is much closer to low than full. I opened the cap and the coolant looks red but wanted to make sure the red was right. What's the PN...

That tie rod jam nut was SUPER tight on mine when I pulled one off. I needed to replace a rack boot and it took longer to get the dang tie rod end off than the whole rest of the job! Found out both outers were bad and need to be replaced. Seems like every time I repair something I find...