I had slight frame rubbing but not body rubbing (pinch welds) when I wheeled it with my last set. I did trim the plastic fender liner that sits just behind the front tires. It's about a 4 inch by 2 inch piece of plastic. That's as much as I did.
They do fit. This is the second set of 315/75/16 KM2's I have ran. Just got these today. All I have is adjusted torsion bars, coils, and wheel spacers. I did not use wheel spacers on my first set.
2 drawers for sale with side trim kit for 100 series.
I purchased the drawers from Slee Offroad new.
Drawers are locking with two keys. All hardware from the 100 install is available but should also fit an 80 and 200.
The drawers are in good condition. I can take pictures if desired.
**Sold**
I second the SAS front end. If I would have done it first prior to replacing the shocks, torsion bars and adding high end shocks, air locker,skid plates and gears, The cost difference would have been close enough to justify. I have too much "invested" now to cosider a SAS.