Recent content by divinealpine

with drive flanges, is it fine to get this from a NAPA type store? or are there recommendations for OEM?

my CV boots leaked a bunch grease everywhere. no tears, just loose boot towards the wheel wheel side on both passenger / driver. im going to replace them. have ordered a new set of OEM. my vibrations are similar to yours, typically around 50-70mph range. non existent when driving in the city...

thx i appreciate the response and advice. i'm trying to R&D quite a bit before i start a thread..

i should've clarified, my steering wheel is not vibrating either. i was assuming that you guys experienced steering wheel vibration if replacing cv's resolved your issue. my vibration is in the body at around highway speeds. when you mention knuckle rebuild thread, could you pls link it? thx!

did you have similar symptoms where vibrations to the body around highway speeds ? seems i have a similar issue but i'm not getting vibration on the steering wheel. i'm going to check my ujoints on the driveshaft with a pry bar and see if there's any play

awesome, good luck! pls post your results, i'm interested to see if it resolves your issue!

any updates since life happened ?

were you able to resolve your issue?

did you ever resolve your issue?

did your guys' steering wheel vibrate too ?

did you resolve your issue?

Hm, that could be an issue then. It is a M14 bolt... but maybe I can get it to work.

Oh wow I didn't know a tool like this existed, I think this might solve my issue. Thank you Jake!

Hi guys, I'm currently in a bit of a situation where I'm trying to install the wings for the Dissent Offroad rear bumper on my Land cruiser and one of the captive nuts came off. I don't think there's a way for me to install the wing while holding a new nut in place on the inside. It's the...

Nice, I've been meaning to get something like this. Thanks!