Anyone have a decent used set of these? Planning to powder coat, so not too concerned about condition as long as they can be blasted and coated. I would take 1, or as many as you have up to 5. Shipping to 33774.
Just realized that the shop that I had remove my engine and do some frame work just snipped the battery wires, fusible link, and a couple other connectors when removing. Lazy.
Looking for a front engine bay or headlamp harness for a 97 80, should include the engine bay fuse box and fusible...
Added a stainless kit with correct M5 flange screws and EPDM UV stable rubber washers to fill the holes left after removing the roof rack on the 80 series.
https://www.overlandmetric.com/collections/stainless-hardware-kits/products/roof-rack-delete-18-8-a2-stainless-80-series
Please put me down as interested. How large are the drink holders, would be nice if they fit a large tumbler cup or bottle and had enough depth to keep them upright. And will definitely want to add rear cup holders for the kids.
I have a good condition fuel tank from a 97 80-series. Had two tanks and had both inspected, cleaned, and recoated and am keeping one, but don't need the other.
Will start by asking $600 shipped but open to offers. I don't have anything but the tank.
Bought these and then went a different direction. New in box. Includes Drivers and Passenger Brackets.
Was going to use these for Scheel Manns, but they will also fit a number of other seats.
$320 for the pair shipped in the lower 48 ~ 20% discount to retail
Full details here...
Doing an engine swap and need the adapter/extension tailpiece that bolts on the rear of the A343 transmission. And the 6 bolts.
PN: 35015-60070
Shipped to 33774
Thanks for taking a look at the site.
We do only have Phillips in stainless unfortunately, but Belmetric does have good gold/yellow Phillips SEMs screws in M6 that should work well.
Agree that pick and pull would be your best bet for that screw if one nearby though.