Recent content by davedave

@Alex79 do you have the drivers side window switch bezel? (Not the switch, just the wood grain bezel)

It’s very likely that the main EGR passageway inside the intake manifold (from where EGR is bolted on through to the middle where the throttle body bolts on) is also clogged. There’s a thread somewhere where a guy points out each of the main passages that get clogged. It’s not too bad to clean...

Sounds like it's your door lock actuators. There are several threads on this, but here's a quick rundown: - The actuators for front DS, front PS, and rear PS are all NLA. There are some aftermarket ones available, but I haven't used them. - The actuators for rear DS and back hatch lock are the...

Are you saying this happens when operating them manually, or with the lock/unlock buttons? If you’re using the buttons, what you’re describing is the behavior you’ll see when your door lock actuator motors are worn out. They won’t always have enough juice to fully move the lock, so that’s why...

I’ve used Pat Bowles body shop in Hendersonville for years. They do great work.

Those part numbers are for the entire housing (I forget if that’s the red or amber lens). I know ARB doesn’t sell the lens separately, and they’ll only sell you the full housing — for around 5x the price of what it sells for retail in Europe.

I spent a very long time researching them. So I think they are Rinder 121211, but it seems that Rinder only sells retail in Europe -- possibly just Spain. The only sites I could find them on were all spanish auto parts sites. Good luck!

@Tennessee80 how much for that wiring harness? I'm in Nashville and can pick up

Interested in front drivers side fender — you mentioned scratches, but does it have dents or clearcoat peel? Also, what’s the condition of the front seats?

lol well that’s exactly how I am with a lot of projects — definitely a bad habit. I think if I do it, I’ll end up going with kilmat or hushmat, as I’ve seen lots of folks use those. Might be helpful to stop by a car audio place to see if they have any recommendations. Let me know what you end up...

Nope, never got around to it. It sounds like a job that’s a pain so I want to make sure I have the right stuff. Still seems like Resonix has the most rabid supporters, but the whole thing seems a little suspect.

Any luck sourcing that red bump stop? I’ve tried Summit but no luck. McMaster-Carr and grainger have plenty of similar options, but trying to figure out the best route.

I’m not; just have a few parts remaining. However, there’s a guy outside Nashville that’s parting out a couple 80s, you can find them on FB marketplace: Log into Facebook - https://www.facebook.com/marketplace/item/1281598365854410/?mibextid=6ojiHh

Yep, so sorry i haven't gotten back to you. Still need to get a quote for shipping for tlc1995. If tlc1995 doesn't end up purchasing I'll ping you dumkopf.

Yep!