I don't know if it makes a difference ,but I'm in the U.S. and the latch on my glove box broke the knob that goes through the glovebox hatch and secures the door. My question is did they use that knob/latch on another vehicle State side...one that might be found in a salvage yard.
I have been working on the cargo area of my 60 here is a link to my build
3d printed cargo lights power outlets steel cargo sides
Led cargo light build
so I did a little more work today
then with both red and white circuits
started building my circuit board
I plan on putting my fuses and all the rear power stuff in the project box in the background
then While the silicone was drying I cut the side panels out for the cargo bay
I...
So this is an experiment for me. I am not very good with electronic stuff yet but anyway here is the rundown. I am building a few cargo lights for my 60. Using a 3d printer 5mm led lights and epoxy a small project box. My plan is to have each fixture contain 3 white lights and three red lights(...
Ok thanks guys I guess its finally time to check the compression because it doesnt really smoke on start up. I have been holding off because i almost dont want to know what the compression looks like haha oh well if its bad ill just drive it until its time to drop a desile or a small block in it
Hey guys,
I have been running down the problems on my 85 fj and it seems like everytime I fix something another problem shows up like dominos, I get it it is 30 years old and had a abusive PO. OK so here is the list of things I have fixed so far
intake gasket and manifolds plained
webber carb...
I changed the oil, filled the t-case, installed a power inverter and put new gas struts that hold the back hatch open, then we went camping at the lake. My wife and I just folded the back seat up and slept in our bags on the floor. It was pretty comfortable. Funny story I thought I got 20w-50...