Recent content by dandycamp

Got the side panels mocked up, cleans up the rear quarters a bit, covers the holes they drilled for the round trailer lights. I’m looking for some stock taillights for my bumper I’m going to build. Is there any reason to spend 100-200$ for tail lights? I don’t need the oem connector plug, that...

Turns out it’s not shipping out, they don’t have it, gotta make my own

So I can’t find a walker y pipe so I’m going to make my own, can I use this Jegs reducer to bolt directly to my 2in rams horns or do I need a different style connector? I’m assuming it would work because the 2in opening on the ramshorns can dump directly into the 2.5in y pipe?

So with Rams horns do I need to run a certain type of gasket or style of reducer( I think that’s what it’s called..) make my own crossover pipe? I don’t see anywhere selling the style That’s on the walker crossover pipe, the first picture I attached. I can only find the type that uses a flat...

Can you send me a link to some 2 1/4 header flanges you would recommend for the 2in rams horns? I can’t figure out which one is the right one. Technically it’s a 3in collector flange right? Could you connect a 2.5 in pipe header flange to 2in rams horns? I was thinking about just making it all...

So these header buddies, do the require a gasket in between them and the rams horns outlet? I’ve seen a few different styles the walker y pipes use one of those soft lead/graphite rings that compress in between, do the header buddies use the same style or something different, or they just seal...

Do you have 2in or 2.5in rams horns? I think I’m going to make my own y pipe. Where do you get the two piece that fit to the header? The exhaust tube and the 3 hole plate that bolts it to the header?

Looks like I might have to make one and use a swedge/pipe expander. And might as well go stainless on the y-pipe since the rest of the exhaust will be stainless. I haven’t removed the old exhaust yet because I want to be able to drive it until I have all the parts to install the new exhaust all...

So I called walker/dynomax and they said they would have more at the end of June… but who knows how long it will be before Jegs or other parts distributers have them available. Does anyone know a part number or what to search for the exhaust fitting/flange that bolts to the rams horns so I can...

So 40261 and 42087 are all sold out when I google those part numbers. Does anyone know a place to find them? Jegs says they have them in stock but I ordered one two weeks ago and Cole to find out it’s on back order and they can’t give me any estimates on when they will have it.. So, does anyone...

I like the 4 plus tire carrier and 675$ ain’t bad either but I like the dual swing out cooler/tire carrier… but it’s 2,225$ it’s basically just two swing out tire carriers put together. I would think it would be close to double the price of the tire carrier but it’s a little bit over three times...

So is this the stock Toyota 4speed or a Muncie 4 speed from the sbc swap?

Ok, false alarm. I called Jegs and it’s supposed to ship out may 30th

So I ordered a 42087 y pipe from jegs, it said it was in stock but apparently it’s back ordered, not sure how long that will take but I plan to call in the morning tomorrow. When I google 42087 y pipe everywhere else is sold out. Not even eBay. Let me know if you know of anywhere else