Recent content by DanDan93

  1. DanDan93

    Ln107 Will not start

    Glad to hear it worked out. That is an interesting technique with the brake bleeder. The Crisis is over?? I should be getting back to my Surf (and service manuals) on Monday . Think I'm going to get brave and replace every fluid at the same time!
  2. DanDan93

    Ln107 Will not start

    Is it hot or cold where you are? Can you get vehicle to run off of starter fluid? when is last time vehicle ran? -Fuel before fully committing to electric rabbit hole..... Is system really primed? Please verify that fuel tank actually has fuel in it; unless you just filled it up recommend...
  3. DanDan93

    1KZ rebuild

    OK, so I got logged out and my response was cut short. If it were my engine I'd be pricing out a few options before pulling engine. 1) price of a new or re-man 1kz short block 2) Pricing of 4x cylinder liners with pistons and rings 3) a machine shop specializing in diesel engine service...
  4. DanDan93

    1KZ rebuild

    Ouch! From the looks of scoring; agree that engine needs to come out. Not sure if the 1kz uses Cylinder Liners or not. The interweb seems to sell them. Search pulled up a thread on here arguing over if 1kz's do or don't utilize cylinder liners.
  5. DanDan93

    Won't start but turns over

    Akd46r It's a diesel right???? Are you sure your truck has an ecu? Did you have the old part in your hand. I'm looking at my drawings and looking at the same page gnob shared. As far as I know I think the 1kz is an old style stupid diesel that does all the on/off and timing magic with the fuel...
  6. DanDan93

    Won't start but turns over

    https://autoparts.beforward.jp/detail/PA110869291/?buynow=1 I purchased my car initially from this website. Parts are available, can be expensive but do exist. I purchased a replacement intake hose from them with no trouble at all. I advise as follows... please be sure that your issue is...
  7. DanDan93

    1kz-te oil grade

    I'm back at home, so here are some pictures of books. The Japanese one came in the glove box, the Haynes manual was from the ebay. Notice how there is no reference to 40w in the oem Japanese one, and the 10w30 is listed as good above -20degC. Good luck Dan
  8. DanDan93

    1kz-te oil grade

    Hello, I've had my 94HiluxSurf: 1kz-te in Northern Marianas, and Houston TX. Both comprable to Florida in climate. After reviewing oil selection guide on owners manual went with 10w30. The guide sort of recommends staying away from 5w30; I forget if that is for really cold or hot. 10w30 covers...
  9. DanDan93

    Won't start but turns over

    Hello, Has your vehicle started at all with existing issue? Could you clarify model and engine? Is it a diesel? Will it start with starting fluid? Are you somewhere cold? I am away from my books and truck for another week. Will help if I can. Good luck
  10. DanDan93

    KZN130 air intake dimensions

    Was trying to source new air filter..... even though post seems a little old. I'm measuring stuff, so here you go Filter can pipe od: 2.770" Corresponding lip od: 2.884" Pipe over intake manifold od: 2.907" Corresponding lip od: 3.008"
  11. DanDan93

    Electric Connector ID help?

    Thanks for all the help. Door locks operational again!
  12. DanDan93

    Electric Connector ID help?

    Thank you @gnob! Looking forward to no longer reaching around the cab to lock up.
  13. DanDan93

    Electric Connector ID help?

    My electric door locks unlock but do not lock. Found the problem and it is the only problem. Broken wire on driver door wire harness. I have the wire harness inside my house and would like to do a quality repair. Feel like making connection where wire broke is bad idea (inside rubber boot...
  14. DanDan93

    NewMember!-Introduction

    Hello, all. Was introduced to this site by a friend. Proud owner of 94'HiluxSurf. Sporting right hand drive, 1kz engine w/ 5 speed. Purchased from Japan, shipped to Marianas Islands (where i used it),moved it home to Houston, TX. anyone else have same set up?
Back
Top Bottom