Recent content by Dan

I think it would be best to just try and find out how much use you could get out of the small bottle. But I am intrested in the math too, does any one know the expansion ratio for liquid co2? Maybe Stainless 40 knows.

Do you have to keep the air cleaner for smog reasons or anything? I run a weber carb on my F with a little K&N filter that sits on top. It really frees up space in the engine bay. My friend left his factory air box for his Super duty ford over here when we put a high flow system on it. I...

I'd just use a floor jack personally. I have the 3 speed out of my 40 right now because I am replacing the engine, but if I were just pulling it by it self I'd do it with a floor jack. That's how I change the clutch in my 87 4 runner and that was a much more difficult trans to handle. As far...

What's the condition of the hard top, doors, and lift gate? Can you send me some pictures? How much for them? I can pick them up next month when I will be in Riverside again.

I sent you another post about some knuckles, same offer, ($125)

I am looking for a top and doors for a 72, let me see some pictures if you could ship to CA. $400 sounds like a good price.

If you are parting out whole axles, I'd like to make you an offer for the complete knuckles, brakes, :Dand birfields for one axle. ($125?) :D

I have a 4runner that sat with water in the cylinders for monthes and got rust in the cylinders. I just cleaned the cylinder walls with steel wool, blew them out with compressed air (lots of air, didn't want to leave anything behind) then put it together checked compression (one cylinder...

I sent you a PM and an Email, I'm going to riverside tomorrow, and I'll be in SD on saturday. But I'll be in Riverside all week after that.

hey I am looking for a 2F to rebuild and stick in place of my F. I am in central CA, where are you, and how much for everything you have left?