Recent content by CruiserDave

  1. CruiserDave

    Maxfab4x4 ac fan kit

    Like stated above, fuse tap with key switched power. I chose a different fuse than the cig lighter since I've repositioned my obd2 port to point downwards. This allows the ultraguage to be plugged in without any interference with the fuse box cover. Working great so far.
  2. CruiserDave

    how different can two LX450's be?

    My 96lx has lockers, spoiler, tow package and green gauges. No phone controls though or gold package.
  3. CruiserDave

    High Lift mount for Dobinsons Rear Bumper

    Still working even with 35" tires now.
  4. CruiserDave

    Maxfab4x4 ac fan kit

    Just finished installing the ac condenser fan kit from maxfab4x4. Easy install and works perfectly. 98 degrees today and to test it I let the vehicle heat soak and idle for around 30 minutes. Fan kicked on and kept ac cool the whole time. I'll see how it does in traffic on the way to and from...
  5. CruiserDave

    Media Official 35" and under!! Post pictures!!

    16x8 Rough Country steel wheel with -12 offset and 315/75r16 Patagonia Mt02 and icon 3" lift.
  6. CruiserDave

    Driver seat recline

    Just to update I brought a new switch box from Japan and swapped it out. Works great again. Faceplate is held in place with tabs so be careful when pressing them down to remove.
  7. CruiserDave

    RTH - engine temp spiked to 216 - overflow boiling

    More than likely bad radiator cap since it was such a low boiling point. Change it out so it hold proper pressure to achieve the higher boiling point needed.
  8. CruiserDave

    I need help distinguishing which engine is in this 80 Series

    Sorry I could be wrong about the stamping part.
  9. CruiserDave

    I need help distinguishing which engine is in this 80 Series

    Aftermarket turbo on 1hz. Intake is blank and doesn't have turbo stamped on it.
  10. CruiserDave

    1995 80 series 4”lift vibration

    I would remove the boxes first, since it's easy, and see how it drives. I know plates used to require modification to the radius arm mounts. Removing them would require work to replace removed material. So remove the drop boxes and try it out. It's free and only uses your time if you're doing...
  11. CruiserDave

    Driver seat recline

    I'll have to dig deeper into searching here. Thanks for replying.
  12. CruiserDave

    Driver seat recline

    I need information on how to remove the seat switch panel. My seat back will recline but not come back up. I've read it could be the contact in the panel. Does anyone have info on how to remove the switch panel without damaging the faceplate?
  13. CruiserDave

    1995 80 series 4”lift vibration

    The boxes and plates are probably to much correction. I ran into this problem with boxes and arms. I removed the boxes and problem cleared but steering is a little lighter. Mine is on a "3 lift but my arms are superpro and don't correction as much as plates.
  14. CruiserDave

    80 series roof rack removal reseal best practices?

    https://www.amazon.com/gp/aw/d/B07V4H9432/?tag=ihco-20 These were posted a while back as working. I haven't tried them though.
  15. CruiserDave

    Rough Country 16x8 -12 offset

    Here's how they look with 315/75/16 tires and icon 3" lift.
Back
Top Bottom