Truck is at body shop now. Trying to decide on how much to cut off. After the wheeling trip, there wasn’t too too much rubbing. Thinking of my aunt saving some room for activities later on.
the body shop guy gave me these two options. White line and yellow line. His preference is the...
Haven’t updated for quite some time. Lots of things happening. 1st, didn’t put the car and left it in 4-Lo wasn’t moving when I left, wife opted to reach across the car and turn it off, it rolled back and I lost a door. This prompted a bunch of things. Found a replacement door locally which...
The delta 3L arms are in. Ordered them with all new hardware and the OEM bushings installed. What a difference in the ride quality. Going from shot bushings to new bushings it glides over bumps now and there’s a lot less noises. After replacing essentially all the steering components, the...
Quick update. Birfs were rebuilt. Along the way, noted the steering gear box was also very leaky. Replaced it with a 105 box. All the tie rods were replaced. Did everything oem. Bushings in the radius arms are shot so ended up ordering the delta 3” long. Slowly planning out the move to...
Super quick shipping from Utah to Hawaii. Cruiserteq rebuild kit. Went with the koyo bearings. After doing a little more inspection of the truck, looks like my steering gearbox is starting to leak. Looking at the options either a full oem with the 105 shaft or getting it rebuilt with 105...
Did a few things. Two trail camp outs and some late night fishing trips. After doing the fishing trip and reversing blindly into the night, I decided it was time to do some sort of back up lights. I had the s2s in the back for a while but the beam pattern didn’t really suit the purpose. Had...
Added RBG rock lights. Don’t really like them so I’ll probably swap it out for some white ones when I get the chance. Was able to get all my lights aimed. The KCs are very nice.
Added some DIY limb risers as well. Only $45 for all the parts from the hardware store.
I was going to have someone install it but they had a last minute emergency. I used the template provided by safari, marked out all the holes and mocked it up a few times before making the final holes. I used a punch then drilled out some pilot holes. After that a hole saw with arbor for the...
First was a simple project, remove and replace the driving lights. This was a relatively quick job.
Test fitted just the light bar and it just barely didn’t fit and it was sitting on the roof so I could not adjust it.
This was the bracket it came with and I figured I could just cut it and...
Someone was selling a brand new KC 50” light bar on fb market for a deal that was hard to pass up. The wife and daughter were going to the mainland for a week so it was a perfect time to do a bunch of work. After I bought the light bar, I opted to replace my broken driving lights mounted to...