Recent content by cattrainer

I put seafoam in my full tank to just maybe clean carb up a bit, it is stumbling and misfiring, will run good for a while and then start to surge and stumble. When you put it in your tank did it eventually clear up? been fighting this for a while but have not burned off a tank of fuel as i...

It is a 19100-60042 original for the F engine that came with the 67

The question now is. I have a vacuum dizzy from a 67 F engine would it fit and work with the 2 F engine?

To all that answered my question thank you. I found that it is a Delco Remy model 1112403. This is from another thread. Some info from the spec sheet: Point gap = .019 Dwell = 28-35 Part numbers: Points = D105P COND = D203 ROTOR = D405 DIST CAP = D306 Timing for the Delco is approx 10-14...

This is inframe pics first pic was image I found doing search for likeness

Here what mine looks like.

I have a distributor with no vacuum advance on my 2F engine. I am trying to find point for it and all the pictures for points when i look up by year don't match. I have tried going up and down in years to see if they were built with different Dizzy's. I have yet to find anything close. It...

Thanks, My temp runs 2/3 way between the needles and seems to stay there. I am just getting this fj40 going with different engine and fixing all the electrical and wanted to make sure of normal. I had a fj40 30+ years ago that i put a small block and i am now starting over with with this 67...

Hello, What should a normal coolant temp be with relation to where the needle normally sits? On the first line or better than half way to the second line, I am talking about the two lines between bottom cold and top end hot. Is there a known exact temp each line represents? I replaced...

No, its for the latter 70 brake master, Like i said earlier is showed the large end cap and was going to do swap like others have done with a clutch master. No such luck, showed up with solid housing drilled.

thank you all for the help, I may have buy another master cylinder. I will have a new 70 version for sale????

I had original, but it is badly scored up in the bore so not rebuildable. bought a master for a 70, because everywhere i looked 67 were out of stock. The pic for the 70 master showed the large end cap and i figured i would just swap my 67 end on to the new master, well part showed and it is...

Fishtacos, the master i have now is for a 1970 fj40, and it uses a 3/8-24. Is the small line fitting a m9x1.0 on my 67?

Looking for some help with master cylinder replacement on my 67 fj40, it has the very small brake lines and i can not find a size for the fitting that screws into the master cylinder. I want to use an adapter fitting so as to use a master cylinder with 3/16th standard fitting. has anyone done...