I want to ask an actual technical question here related to the plug and play alternators @SNLC,
Do higher amperage alternators require more work put in from the motor at a general idle to maintain the stated current measurement? I’m assuming it’s pretty negligible added resistance when...
Fresh:
That actually does help some. Do you know where the seatbelt bracket lines up in that stack? I have spacers on mine as well.
I ordered a new driver side seatbelt from Toyota parts express, and will get that soon. I will take pictures of the OEM belt with hardware supplied to give the...
Hi all,
Does anyone know the order the seat belt hardware stacks for the front?
I have lock washers, washers, spacers and rubber grommets strewn all over the floor and I can’t seem to correctly recreate the stackup.
I should have taken a picture of the order originally. I know I know.
Any...
Pulling this thread out of the depths.
Passenger side front seatbelts NLA for my 1993 according to my search. Having an issue with the passenger one currently as it seems to be locking up at any orientation except straight up. There should be a +- angle of 15 degrees according to the FSM, and...
Pleased to see where this discussion took off. A lot of useful insight to cruiser curious folks, and myself included to see that I'm right in the same boat with everyone else. If any vehicle needs love, it's this cruiser series.
Cheers.
Marketplace specs are quite ridiculous. My truck initially debuted on FB for 16k. It sat for two months and the guy needed to get rid of it during a move, so he was desperate to sell. A PPI pointing out all the neglect, got him to come almost halfway down which was much more reasonable to me...
I (Gen Z) happen to fall into this same group of thought. New vehicles look like a nightmare to service or diagnose. The simplicity of older toyota design is definitely a big reason to me, that I don't need to be reliant on anyone if I can invest in the tools. Also, the fact they were designed...
I would love to be able to do this at a point in my ownership. The task of pulling an engine seems extremely daunting to me without someone to do it with. I will have to study the FSM and prepare at some point. My engine is only at 184k so mine is a baby compared to yours! Haha
This is my experience as well. Definitely not upset at the pay to play game and I definitely fall into the starter category.
I agree with your expectations. I couldn’t afford a great spec truck off the bat and decided within my budget I could spoon feed the repairs. So far it’s been slowly...
I perhaps misspoke,
I have spent 14k on parts I have done myself, and shop help in total. Purchase price was about 8.5k. I think I was generally indicating that it needs more work even after all that. I rebuilt my knuckles, installed new birfields, serviced my rear axles, put new...