Recent content by BWolfe

Also dropped my spare and applied por15 to the rear section of the frame and crossmember. Did the passenger side first so you can see a before and after. Over the past 6 weeks I applied por15 to ~90% of my frame.

Installed the scangauge 3 mount from @BenCC. Used a super slim rj45 cable and Ethernet coupler that made running the cable through the A pillar a breeze.

Overall pretty happy with the end result. Jamie @ Mobile Pro Auto Glass in Charlotte is knowledgeable about installing 100 series glass.

Make sure the top molding (part 75531-60030) is nice and straight prior to install.

Close-up of larger rivets on passenger side. While it keeps the molding & windshield in place properly, it makes it difficult to install the cover gasket (part 75543-60020).

Passenger side. New molding sits lower so you can see custom paint chipping...

Same question from a different angle

Is this gap ok like it is, or should I fill it? I have a Prinsu rack...

The "gasket on my passenger side cowl is pretty rough. Can this be replaced without replacing the entire cowl?

After having the install done, here's an updated list of the parts: 56111-60272 - Windshield Glass 87805-60010 - Inner rear-view mirror base sub-assembly Qty. 1 Do not need if purchasing windshield 56115-02010 - Back window glass #1 stopper Qty. 2 Previous part number 56115-33020 Do not...

Apologies for the delay in update. I’ll give a full right up tomorrow as I have a couple questions now that I’m done.

2000 LC - I was running a cable through my A pillar, and when I was done I noticed this fuse was dangling. Wasn’t there prior, and it looks like there is a bracket connected to the wring assembly behind it that it mounts to… Am I on the right track here?

I’m looking for exactly this. Did you ever figure out if you could replace just that trim?

This is a 2000 LC. Are the small hoses between the charcoal canister / EVAP service port and the switching valve / fuel vapor hose specific part numbers or are they cut to length?

Are you replacing that cowl molding? I didn’t think about that but now I’ve got that little gap between it and the windshield