Recent content by Brutherb

I haven’t started looking yet but is there a resource that show the location of connections and diagrams for wiring for a 99 100 series. My issues are this and I think they are all related. it started with when I unlock my door my alarm goes off, now the rear hatch key doesn’t work at all...

Sorted out the issue thank you

Previous owner replaced rear taillights with led ones. I have never worked with led light systems beyond standard bulb replacement. Either way Brake lights are not working and the bulbs are not replaceable. But before I go and order new taillights I would like to check the system out to make...

Mine is a 99, so hopefully not

just jack up the engine or do you have to undo the motor mounts

I am about to replace my steering rack. Looks like a straight forward process. Question is there and online filter either in the resivior or somewhere else that I should replace. Second question on other rack I have replaced you just fill up the resivior with fresh fluid and cycle the the...

Thanks, if the rear hatch lock cylinder does Not lock or unlock any of the doors, but the actuator works if I use the electric locks switch on the door, is that a wiring issue then,

Could you post a link to the door actuator thread that your talking about as I am sure if I search as I have several will come up.

99 LC, new owner. If I put my key in either the drivers or passengers door the door unlocks but it sets the alarm off. as well randomlyyou can hear the locks trying to lock the doors. It doesn’t unlock themyou can just hear them cycling. I have read that the rear hatch wiring can be an issue...

I had to replace a few front end part on a new to be 100 series, just buttoning it ip today as i have been waiting for a new axle flange. The videos I have seen show it easily sliding on mine needs a bit of persueding, if I flip the axle flange around (the wrong way) it does not go over the tip...

I think I figured it out m8x1.35

My shaft won’t come through the flange easily do I am going to finish pulling it through with a socket but bolt and washer I have a bolt that threads on for reference but wondering if anybody know the actual bolt size and thread

Thanks for all the responses going to try bleeding them first might see if I can find a mobile mechanic with a power bleeder, I don’t have one and just do a full flush of the system.

The vehicle is new to me and I bought it damaged. Right front bearings went and the owner kept driving it, but I don’t think that anything he did would add air to the brakes, but you never know

When I press down on the brake pedal there is no resistance except maybe the last inch which will engage the brakes. If I pumo it it doesn’t build pressure and then soften there is just no pressure. I am not thinking that they need bleeding, but maybe any other ideas. I am not familiar with the...