Recent content by brendonv101

  1. B

    Disc brakes: To grease or not?

    I spray the pins with lithium spray. Doesn't attract dirt like grease and doesn't weep out with heat.
  2. B

    Disc brakes: To grease or not?

    I've never greased around the pad. Only the slide pins. If the slide pins go dry they can jam and cock the caliper over causing them to wear on an angle.
  3. B

    HOW TO: Fault finding factory cruise control system

    Hey guys, I got my non functioning cruise control working in my manual 80 series. I also retrofitted it to work with my dbw 1hd-fte swap. I've made a series of videos going quite in depth on fault finding the whole system. I also have videos on removing and setting the aneroid pin on 1hdt...
  4. B

    Knock/ tapping sound from gearbox under full load

    I'll take some pics today. The input bearing has about 2-3mm of end float within the bearing. I can move the centre race in my hand easily. In the box it's a fair amount. The shaft also has a lot of axial play. The seal is bubbled and there's no grease in the bearing. Outer race is a bit blue. I...
  5. B

    Knock/ tapping sound from gearbox under full load

    Pulled box off. Throw out bearing and input shaft bearing in gearbox are both flogged. Inspected a gears I can see in box with input out and all look ok. Input has a lot of end float. Clutch looks ok. Will be replacing the lot though and hopefully that fixes it. Gearbox turns nicely by hand but...
  6. B

    Knock/ tapping sound from gearbox under full load

    Just fitted my new gturbo a few weeks ago and stating pushing more power through the car. I have developed a knock/tap sound from the gearbox area. Starts at about 1850-2500. Under lesser load it doesn't do it. I can almost make it do it with throttle input. I have replaced engine/trans mounts...
  7. B

    Part time question.

    You sure theres no burrs on the alignment dowels and the hub was jamming on them? Would explain why it cracked in two spots. Very unusual regardless of the casting strength to crack there. Make sure its sitting flush with the hub first before tightening the nuts.
  8. B

    Registry 80 Series Registry

    1991 HDJ80 Sahara Brendon Just shy of 500,000km on the clock Since owning the car i have done many many things to it. I started out by fixing every single leak on the car and all fluids. So far i have replaced the following: All wheel bearings Axle seals Front damper Big end bearings (Where i...
  9. B

    The Official 1HD-T/FT Fuel Pump Mod Tuning Thread

    Im from Australia. About 10 minutes down the road from Gturbo haha.
  10. B

    The Official 1HD-T/FT Fuel Pump Mod Tuning Thread

    Morning guys, I was the one that made those two youtube videos posted a few pages back. I've recently purchased a gturbo grunter extreme so im now starting to modify the aneroid. May do a few videos on some road tuning soon. So far i've set the main fueling for a rough peak egt of 450deg post...
Back
Top Bottom