Recent content by Blue1

I looked on your site and couldn't find these. I could just not be looking tin the right spot though.

I'm hoping the previous owner at least left you the fuse box inside the cab. I bought a cheap little tool from Harbour Freight to chase down electrical drains. It plugs in to where the fuse goes for that circuit and should tell you the amperage draw. It will at least point you in the right...

I have the one I pulled off mine when I put the Cruiser outfitters bumpers on so I would be happy to give that to you. I will message you directly and we can make a plan to get it to you.

Do you just want the rear tire carrier that mounts on the right rear door ?

In August I did another run down to Dallas by way of Salt Lake City. the guys at @cruiseroutfit did a very last minute scramble and put together everything need for their front and rear 70 series bumpers. I am finally in the process of putting them on. About to tackle the front bumper and I am...

Fender flairs, FRP top and rear doors going on

Spared one coat of base then installed fender flair brackets. I used seam sealer as well when I riveted on the brackets. Another good coat of base then a couple coats of clear. The base coat color match was very good but for some reason the original clear is a bit darker ( where the existing...

Again I missed taking photos of several steps. Rear quarters both on, primed and color matched bedliner going on.

Slowly making pieces and patching it back together. Rebuilding the bottom corner of the tail light " bucket " was a bit of a challenge.

Right rear corner still

Now I dig in to the right rear inner corner

Right rear cargo door area, again I am missing some progress photos. I dropped the tank to make sure I could access everything. I used ear plugs to block off the supply and return fuel lines which created a fun problem later on.

I definitely missed taking some step by step shots. I was in a rush after patching the right foot well and sprayed chassis saver with very poor prep so I went back and cleaned it up and resprayed but didn't get any more photos

Well Its October now and I have fallen very far behind on posting so I will try to get caught up. I am going through photos from April until now so they may be a bit out of order as I bounced around and worked on different areas. These four are the right rocker area

Those patches look great ! Lots of really good progress. I ended up dropping the tank on mine so I could chassis coat the underside of all my floor patches in the back. I agree, first time around it's not a lot of fun but after the third time it you get into a rhythm and its pretty quick ( but...