Recent content by bls72bmw

Team, I converted to a dongle antenna, so I don't need the mast going up/down every time I use the radio. I can't seem to find a pic of where the antenna relay is actually located....the google searches show me it should be somewhere under the passenger side dash, but if there is an easier way...

Thanks for the help, jumped those two on mine and it didn't work, but I've got a 2000LC- will have to check the diagrams. Thanks for pointing it out.

Richie! Exactly what I needed to know. huge thanks To more clarify, when you say jumper wire, whet did it go to/from? the ACC relay both sides of the fuse to....

What did you run them to? By chance any pics?

Team, Mounting up a dog kennel in the back for Grouse Hunting. I'd like to find an easy way to wire this outlet to be constant hot so I can run the kennel fan when I'm not with the Rig. Is there an easy way to do this? Anyone done it? Thanks!

Cleaning the closet and selling some trail spares I had: DENSO Coil Pack (in sealed plastic bag) #673-1303, Drive Belt from a 98 LC100, and an Axle Nut Wrench 54mm that I got off Amazan and paid $45 for, used one each axle once OTC (6612) 54mm Hex Locknut Socket For Toyota FJ, LN, And RN Models...

Stuff sitting in my office still.... lowered it to $40 shipped.....I mean shipping will be like $12.....so this is a steal for some nice clean trail spares. If you want pics, PM me your cell please.

$50? Cleaning out, it's gotta Gooooo

the belt is unknown make

Still available...

LOWERED TO $40/SHIPPED Team, Found some extra trail spares I have, but never used. New Denso 673-1303 Coil Pack (new in box) Also a nice clean Serpentine belt, brand unk. Both fit a LC 100. How about $65/OBO shipped at my cost, USPS Slow Boat shipping Thanks.

Thank you a ton responders! I was wondering if I had to pull this sucker out again. Super helpful. Appreciated.

I'd been using OlathePartsOnline, their prices are not the best, but they will take some time to help you. However, as of late, I've found cruiseroutfitters, they will take time to help you out, give you resources that the OEMs don't have (like aftermarket ball joints that OEMs don't sell) and...

Installing new front driveshafts, half shafts, cv shafts (whatever we all call them!) on my 98 LC100. I watched a ton of videos, but in one the gent says "install with the open end of the snap ring facing downward". So, I don't remember what side I put the open end of the snap ring....on one...

Thanks for the fast replies. I wasnt sure if going to 17 over 16" wheels would give me a better tire selection or more off road tire to use.